I V . A S S E M B L Y
INITIAL ASSEMBLY
Your power chair may require some assembly either before initial use or after transportation.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be replaced with a new nylon insert lock nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local hardware stores or through your authorized Pride Provider.
Seat Installation
It may be necessary to install the seat either prior to initial operation or after transporting your power chair.
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so.
To install the seat:
1. Slide the seat down onto the power base. See figure 11.
NOTE: The bottom hole on the seat post is equipped with an internal welded pin, which sets the seat height in the lowest position. If a seat height other than the lowest position is desired, you must install the supplied clevis pin into either the middle hole or top hole on the seat post before installing the seat.
2.Tighten and clamp the
3.Install the joystick module into one of the armrests. Tighten the setscrew with the supplied hex key. See figure 11.
4.Lift the armrest straight up, then route the joystick module cable and secure with
WIRE TIES |
|
| SEAT |
SETSCREW | JOYSTICK |
MODULE | |
QUICK RELEASE |
|
FASTENER |
|
| CLEVIS PIN |
POWER BASE |
|
NOTE: It is important that the armrest be lifted Figure 11. Seat and Controller Assembly straight up prior to securing the joystick module
cable with wire-ties.
MANDATORY! Prevent controller harness damage! Use correct tie- down points for controller harness.
5.Plug the joystick module cable into the connector on the power base. See figure 6 or 7.
Jazzy Select Series | www.pridemobility.com | 23 |