V I I . C A R E A N D
5.Slide the new wheel back onto the shaft. Make sure that the key is in the axle slot.
6.Reinstall the drive wheel nut and washer onto the axle and tighten.
7.Remove the power chair from the blocks.
Battery Replacement
A battery wiring diagram is printed on a decal located on the front battery tray. See the Specifications Table for cor- rect battery specifications.
WARNING! Battery posts, ter minals, and related accessories contain lead and lead compounds. Wear goggles and gloves when handling batteries and wash hands after handling.
WARNING! The batteries in your power chair should only be serviced or replaced by an authorized Pride Provider or a qualified technician.
WARNING! Do not replace batteries when seat is occupied.
WARNING! Power chair batteries are heavy. See specifications table. If you are unable to lift that much weight, be sure to get help.
WARNING! Use proper lifting techniques and avoid lifting beyond your capacity. Do not mix or match new and old batteries. If you encounter a situation where one battery needs to be replaced, then replace both batteries. Refer to specifications table in this manual and the manual supplied with the battery charger for recommended type and capacities.
To replace the batteries:
1.Lift up on the shroud and slide the tabs out as shown in figure 17.
2.Disconnect the battery strap.
3.Remove the red (+) positive and black
4.Remove the batteries.
5.Place the new batteries with the terminals facing out as shown in figure 18.
M A I N T E N A N C E |
AXLE KEY |
DRIVE WHEEL NUT |
AXLE SLOT |
DRIVEWHEELWASHER |
Figure 16. Select Traveller Drive Wheel
Figure 17. Shroud Removal
- | + |
+ | - |
Figure 18. Battery Orientation
34 | www.pridemobility.com | Select Traveller |