Pride Mobility INFMANU4440 manual Elevators, LIFT/ELEVATION Products, Batteries

Page 15

I I . S A F E T Y

ELEVATORS

Modern elevators have a door edge safety mechanism that, when pushed, reopens the door(s).

If you are in the doorway of a elevator when the door(s) begin to close, push on the rubber door edge or allow the rubber door edge to contact the scooter and the door will reopen.

Use care that pocketbooks, packages, or scooter accessories do not become caught in elevator doors.

NOTE: If your scooter’s turning radius is greater than 60 in. (152.4 cm), it may be difficult to maneuver in elevators and building entrances. Use caution when attempting to turn or maneuver your scooter in small spaces, and avoid areas that might pose a problem.

LIFT/ELEVATION PRODUCTS

If you will be transporting your scooter during travel, you may find it necessary to use a vehicle-mounted lift system or elevation product to aid in transportation. Pride recommends that you closely review the warnings, instructions, specifications, and safety information set forth by the manufacturer of the lift/ elevation product before using that product.

WARNING! Not all lift systems/elevation products are rated for use with an occupied mobility device. Pride recommends that you do not remain seated in your scooter when it is being used in connection with any type of lift system/elevation product unless:

That product is rated for occupied use by the manufacturer.

You are able to occupy your mobility device in strict conformity with the warnings, instructions, specifications, and safety guidelines set forth by the manufacturer.

WARNING! Always turn off the power to the unit when you are being transferred via an elevation product. Failure to do so may result in accidental throttle control lever contact, resulting in unintended movement and personal injury or product damage.

BATTERIES

In addition to following the warnings below, be sure to comply with all other battery handling information.

MANDATORY! Battery posts, terminals, and related accessories contain lead and lead compounds. Wear goggles and gloves when handling batteries and wash hands after handling.

WARNING! Scooter batteries are heavy. See specifications table. If you are unable to lift that much weight, be sure to get help. Use proper lifting techniques and avoid lifting beyond your capacity.

WARNING! Always protect the batteries from freezing and never charge a frozen battery. Charging a frozen battery may result in damage to the battery.

WARNING! Connect the battery harnesses in the proper manner. RED (+) cables must be connected to positive (+) battery terminals/posts. BLACK (-) cables must be connected to negative (-) battery terminals/posts. Protective caps should be installed over all battery terminals. REPLACE cables immediately if damaged.

BATTERY DISPOSAL AND RECYCLING

If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag and contact your local waste disposal agency or authorized Pride Provider for instructions on disposal and battery recycling, which is our recommended course of action.

Celebrity X LE

www.pridemobility.com

15

Image 15
Contents Page F E T Y G U I D E L I N E S N T E N T S Shipping and Delivery SafetyN T R O D U C T I O N PURCHASER’S AgreementS a F E T Y Product Safety SymbolsS a F E T Y S a F E T Y S a F E T Y Removable Parts PRE-RIDE Safety Check GeneralModifications Weight Limitations Tire InflationIncline Information S a F E T Y Braking Information Cornering InformationCorrect Curb Approach Outdoor Driving SurfacesDoors Inclement Weather PrecautionsFreewheel Mode Stairs and EscalatorsBatteries Battery Disposal and RecyclingElevators LIFT/ELEVATION ProductsGetting Onto and OFF of Your Scooter Preventing Unintended Movement Motor Vehicle TransportALCOHOL/SMOKING Reaching and BendingPositioning Belts Prescription DRUGS/PHYSICAL LimitationsS a F E T Y Tiller Console Key SwitchBattery Condition Meter I . Y O U R S C O O T E ROff-board Charger Port Lights SwitchSpeed Adjustment Dial Throttle Control LeverAnti-Tip Wheels Motor/Transaxle AssemblyTiller Console Fuses Rear ComponentsSafety Flag Bracket Optional To install the flagManual Freewheel Lever Securement Points Main Circuit Breaker Reset ButtonCharging Your Batteries Reading Your Battery VoltageB a T T E R I E S a N D C H a R G I N G Batteries and ChargingCan I use a different charger? Frequently Asked QuestionsFollow these easy steps to charge your batteries safely How does the charger work?How can I get maximum range or distance per charge? How can I ensure maximum battery life?What type and size of battery should I use? How often must I charge the batteries?You may need the following to change your batteries How do I change a battery in my scooter?What about public transportation? Why do my new batteries seem weak?Getting Onto Your Scooter PRE-RIDE Adjustments and ChecksP E R a T I O N Before Getting Onto Your ScooterGetting OFF Your Scooter Power Down Timer FeatureC O M F O R T a D J U S T M E N T S Tiller Angle AdjustmentArmrest Angle Adjustment Seatback AdjustmentC O M F O R T Seat Rotation AdjustmentFRONT-TO-BACK Seat Adjustment Seat Height AdjustmentPositioning Belt Optional Mirror PositionI . D I S a S S E M B L Y a N D a S S E M B L Y DisassemblyAssembly Frame SeparationSection. See figure I I . B a S I C Troubleshooting Diagnostic Fault CodesWhat if all the systems on my scooter seem to be dead? What if the main circuit breaker repeatedly trips? C a R E a N D M a I N T E N a N C E Motor Brushes Transaxle AssemblyWheel Replacement Axle Bearings and the MotorTo replace a fuse Fuse ReplacementNylon Lock NUT Replacement ABS Plastic ShroudsDisposal of Your Scooter Storing Your ScooterA R R a N T Y Implied Warranties Service Checks and Warranty ServiceCelebrity X LE Specifications P E N D I X I Specification S10.16 cm T E S Page INFMANU4440