V . D I S A S S E M B L Y
To disassemble your power chair:
1.Turn off the power to the controller.
2.Disconnect the controller connector from the electronics tray. See figure 6.
3.Disconnect the charger inhibit connector from the electronics tray. See figure 6. Squeeze the latch release levers on the connector and pull it firmly from the socket.
4.Flip up the seat latch safety. See figure 13.
5.Squeeze the seat latch and release the seat from the front trapeze bar.
6.Slide the seat forward and remove it from the power base.
7.Remove the ball detent pins from the seat posts and remove the front and rear trapeze bars. See figure 14.
8.Remove the foot platform. Slide the mounting bracket up the vertical bar of the front frame until the tabs on the mounting bracket can be pulled forward through the matching slots in the front frame. See figure 15.
9.Disconnect the battery connectors and the motor connectors from the power base. See figure 6.
10.Lift and remove each battery box. See figure 16.
11.Remove the battery well frame. Squeeze together the latch release levers that hang vertically down from the crossbar at the rear of the battery well frame. See figure 17.
12.Lift up the battery well frame. Pull it to the rear of the chair to release the front slots from the locating pins on the front frame bottom bar. See figure 18.
13.Remove the left and right frame assemblies from the front frame. Stand behind the power chair and grasp the frame assembly handle on the side you wish to disassemble first. See figure 19.
14.Use your hand and thumb to hold the front frame and press and hold (toward the center of the front frame) the silver- colored latch release lever.
15.Hold the frame assembly with one hand and push the frame assembly outward.
16.Pull up on the front frame with your other hand until the latching mechanism releases.
17.Keep pulling upward with your hand until the locating pin on the bottom of that side of the front frame releases from its slot in the frame assembly. See figure 20.
18.Carefully let the frame assembly tilt to a resting position.
NOTE: Follow the disassembly procedure in the reverse order to assemble the unit.
Figure 13. Seat Latch Safety
BALL DETENT
PIN
SEAT POST
Figure 14. Removing the Trapeze Bars
Figure 15. Removing the Foot Platform
Jazzy 100 | www.pridemobility.com | 21 |