V . C O M F O R T A D J U S T M E N T S
NOTE: The most common configuration of the seat adjustment hardware is shown in figure 19. Your product may be equipped with a different configuration. All configurations operate in a similar manner.
Manual Recline Seatback Adjustment
If your power chair is equipped with a manual recline seatback, you can adjust the seatback angle with the seatback release lever. The lever is located on the right side of the seat base. See figure 19.
To adjust the recline angle:
1.Pull up on the seatback release lever.
2.Lean forward or backward to the desired position.
3.Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with a
JAM NUT |
ARMREST |
ANGLE |
ADJUSTMENT |
SCREW |
ARMREST |
HEIGHT |
ADJUSTING |
SETSCREWS |
ARMREST WIDTH |
ADJUSTMENT |
HARDWARE |
SEATBACK |
RELEASE |
LEVER |
To adjust the seatback angle: | Figure 19. Armrest and Seatback Adjustments |
1.Remove the adjusting screws from each seat hinge.
2.Set the seatback at the desired angle.
3.Reinstall the adjusting screws to each seat hinge and tighten.
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
NOTE: Changing the armrest width may increase the overall width of your power chair.
To change the armrest width:
1.Locate the adjustment hardware on each side of the armrest receiver bracket. See figure 19.
2.Loosen the adjustment hardware.
3.Slide the armrests in or out to the desired width.
4.Tighten the adjustment hardware.
Armrest Angle Adjustment
To change the armrest angle:
1.Lift the armrest straight up so that it is perpendicu- lar to the floor. See figure 19.
2.Loosen the jam nut.
3.Turn the adjusting screw to raise or lower the front of the armrest.
4.Tighten the jam nut to lock the adjusting screw into place.
28 | www.pridemobility.com | Jazzy Select Series |