Pride Mobility Cantilever Lift System manual Cantilever Lift Operation Remote Plus

Page 10

10

Basic Operation Instructions

CANTILEVER LIFT OPERATION - REMOTE PLUS

To operate the cantilever lift:

1.Bring your power chair to a complete stop.

2.Press the mode key until the actuator indicator lights up. See figure 4.

3.Push the joystick forward to raise the lift. Pull the joystick back to lower the lift. Once the lift reaches its highest extension and the lift action stops, you should continue to hear and/or feel the lift motor running. This is because there is a clutch mechanism that allows the motor to continue running after the lift has reached its limit. This clutch works at both the top and bottom extensions of the lift. When you release the joystick, the lift motor will stop.

NOTE: Do not allow the motor to run more than a few seconds after the mechanism reaches the top or bottom limit.

4. Press the mode key again until the speed setting indicator lights up.

SPEED

SETTING INDICATOR

MODE

KEY

ACTUATOR INDICATOR

Figure 4. Remote Plus Controller

Cantilever Lift System

www.quantumrehab.com

RevA/Nov03

Image 10
Contents Cantilever Lift System Product Safety Symbols Table of Contents Internet and Private Purchases SafetyPURCHASER’S Agreement Information Exchange Pride OWNER’S ClubCantilever Lift System Cantilever Lift SystemUse Lift on Flat, Hard, Level Surface Only Vibe with Cantilever Lift System Specifications Cantilever Lift Operation VSI To operate the cantilever liftCantilever Lift Operation Remote Plus Remote Plus ControllerCantilever Lift Operation Europa Europa ControllerSeat Dump Adjustment To adjust the seat dumpSeat Dump Adjustment Seat Position Adjustment Contoured Seat UMSMonth Limited Warranty Quality Control Cantilever Lift System