Pride Mobility 600 SP manual Controller Position, To extend the controller

Page 26

 

V . C O M F O R T A D J U S T M E N T S

Controller Position

MOUNTING

You can move the controller in toward or out away from

SCREWS

the armrest, or change the position of the controller for ei-

 

ther left-hand or right-hand use.

 

 

WARNING! Do not place the controller

 

 

harness so that it can be pinched in the

 

 

seat frame or the power base frame.

 

To extend the controller:

 

1.

Flip up the armrest so it is perpendicular to the floor.

 

2.

Loosen the setscrew on the controller bracket. See

SETSCREWS

 

figure 16.

 

3.

Slide the controller into or out of the armrest to the

 

desired position.

Figure 15. Controller Position Mounting Bracket

4. Tighten the setscrew to secure the controller.

 

NOTE: If your power chair is equipped with a Spe- cialty Seat, Synergy Seat, or TRU-Balance Power Po- sitioning System, loosen the setscrews in the mount- ing block, slide the controller in or out to the desired position, then tighten the setscrews. See figure 15.

To change the controller position:

1.Turn off the power to the controller.

2.Loosen the rear shroud fasteners and remove the rear shroud.

3.Unplug the controller connector from the power base.

4.Remove any wire ties securing the controller cable to the armrest.

5.Flip up the armrest so it is perpendicular to the floor.

6.Loosen the setscrew on the controller bracket

7.Slide the controller out of the armrest.

8.Loosen the setscrew in the other armrest.

9.Place the controller in the other armrest.

10.Tighten the setscrew in each armrest.

11.Route the controller cable to the back of the power base and plug in the controller.

12.Replace the rear shroud and tighten the fasteners.

13.Secure the controller cable to the armrest with wire ties.

NOTE: If your power chair is equipped with a Spe- cialty Seat, Synergy Seat, or TRU-Balance Power Po- sitioning System, loosen the mounting screws in the mounting block, transfer the mounting block and con- troller to the opposite armrest, and tighten the mount- ing screws. See figure 15 .

CONTROLLER BRACKET

SETSCREW

Figure 16. Underside of Armrest

+

26

www.quantumrehab.com

Quantum 600 Series

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Quantum F E T Y G U I D E L I N E S Quick Reference InformationN T E N T S IIIPURCHASER’S Agreement SafetyN T R O D U C T I O N Shipping and DeliveryProduct Safety Symbols S a F E T YS a F E T Y S a F E T Y Quantum 600 Series Modifications Pre-Ride Safety CheckGeneral Guidelines Incline Information Weight LimitationsTire Inflation Cornering Information Freewheel ModeBraking Information Stationary Obstacles Steps, Curbs, etc Inclement Weather PrecautionsPublic Streets and Roadways Outdoor Driving Surfaces Elevators Stairs and EscalatorsDoors Lift/Elevation ProductsBatteries Transfers Prescription Drugs/Physical LimitationsAlcohol/Smoking Electromagnetic and Radio Frequency Interference EMI/RFIQuantum 600 Series Power Chair I . Y O U R P O W E R C H a I RQuantum 600 Series Power Base Electrical ComponentsElectrical Components Shown with Onboard Charging System Manual Freewheel Levers To operate the manual freewheel leversInitial Assembly A S S E M B L YSeat Installation To install the seatSeat Height and Seat Angle Adjustment Comfort AdjustmentsYou may need the following to make comfort adjust- ments O M F O R T a D J U S T M E N T STo adjust the seatback angle Seat Position AdjustmentManual Recline Seatback Adjustment To change the positionArmrest Angle Adjustment Seatback Angle AdjustmentArmrest Width Adjustment Armrest Height AdjustmentTo change the controller position Controller PositionTo extend the controller Foot Platform Angle Adjustment Foot Platform Height AdjustmentFoot Platform Depth Adjustment Charging the Batteries B a T T E R I E S a N D C H a R G I N GBatteries and Charging Battery Break-in To charge the batteries using an off-board chargerTo charge the batteries using an onboard charger To break in new batteries for maximum efficiencyFrequently Asked Questions FAQs How should I store my power chair and its batteries? Why do my new batteries seem weak?How can I ensure maximum battery life? What about public transportation?Temperature Care and MaintenanceShould your power chair come in contact with water I . C a R E a N D M a I N T E N a N C ETo check the brakes Daily ChecksWeekly Checks Monthly ChecksWheel Replacement Disposal of Your Power ChairCleaning Instructions StorageBattery Replacement Quantum 600 Series DriveWheelBattery Installation To replace the batteries When to See Your Quantum Rehab Specialist for ServiceCorrective Maintenance I I . W a R R a N T Y Service Checks and Warranty Service Reconditioned Units WarrantyWarranty Exclusions Exclusions also include components with damage caused byP E N D I X I Specification S SpecificationsQuantum 600 Series Dimensions and Ground Clearance T E S Quality Control Quantum 600 Series
Top Page Image Contents