Pride Mobility 600 SP manual To replace the batteries, Corrective Maintenance

Page 37

V I I . C A R E A N D M A I N T E N A N C E

To replace the batteries:

1.Turn off the power to the controller.

2.Make sure that the power chair is in drive mode. See III “Your Power Chair.”

3.Loosen the rear shroud fasteners.

4.Remove the rear shroud.

5.Disconnect the battery harness from the rear battery.

6.Remove the retaining clips and lift off the front cover using the foot platform bracket. See figure 17.

7.Slide the battery tray forward.

8.Disconnect the battery harness from the front battery.

9.Undo the hook and loop straps from both batteries.

10.Remove the batteries.

11.Replace with new batteries.

12.Fasten the hook and loop straps around both batteries.

13.Connect the battery harness to the front battery according to the battery wiring diagram. See figure 22.

WARNING! Make sure you tighten the fasteners so that the connections are secure.

14.Slide the battery tray back into the power base.

15.Connect the battery harness to the rear battery.

16.Reinstall the front cover.

17.Reinstall the rear shroud and tighten the fasteners.

18.Charge the batteries. See VI. “Batteries and Charging.”

When to See Your Quantum Rehab Specialist for Service

The following symptoms could indicate a serious problem with your power chair. If necessary, contact your Quantum Rehab Specialist. When calling, have the model number, serial number, nature of the problem, and the error code if available.

!Motor noise

!Frayed harnesses

!Cracked or broken connectors

!Uneven wear on any of the tires

!Jerky motion

!Pulling to one side

!Bent or broken wheel assemblies

!Does not power up

!Powers up, but does not move

Corrective Maintenance

If the battery condition meter does not light up when you turn on the power:

!Check the harness connections. Make sure they are tight.

!Check the circuit breaker. Reset it if necessary.

!Check the battery connections.

If the above conditions prove normal, you can load test the batteries with a battery load tester. These testers are available at automotive parts stores. Disconnect both batteries before load testing and follow the directions that come with the load tester. If either one of the batteries fails the load test, replace both of them. If your power chair still does not power up, contact your Quantum Rehab Specialist.

Quantum 600 Series

www.quantumrehab.com

37

Page 36 Page 38
Image 37
Page 36 Page 38
Contents Quantum Quick Reference Information F E T Y G U I D E L I N E SIII N T E N T SN T R O D U C T I O N SafetyPURCHASER’S Agreement Shipping and DeliveryS a F E T Y Product Safety SymbolsS a F E T Y S a F E T Y Quantum 600 Series General Guidelines Pre-Ride Safety CheckModifications Tire Inflation Weight LimitationsIncline Information Braking Information Freewheel ModeCornering Information Public Streets and Roadways Outdoor Driving Surfaces Inclement Weather PrecautionsStationary Obstacles Steps, Curbs, etc Doors Stairs and EscalatorsElevators Lift/Elevation ProductsBatteries Prescription Drugs/Physical Limitations TransfersElectromagnetic and Radio Frequency Interference EMI/RFI Alcohol/SmokingI . Y O U R P O W E R C H a I R Quantum 600 Series Power ChairElectrical Components Quantum 600 Series Power BaseElectrical Components Shown with Onboard Charging System To operate the manual freewheel levers Manual Freewheel LeversA S S E M B L Y Initial AssemblyTo install the seat Seat InstallationYou may need the following to make comfort adjust- ments Comfort AdjustmentsSeat Height and Seat Angle Adjustment O M F O R T a D J U S T M E N T SManual Recline Seatback Adjustment Seat Position AdjustmentTo adjust the seatback angle To change the positionArmrest Width Adjustment Seatback Angle AdjustmentArmrest Angle Adjustment Armrest Height AdjustmentTo extend the controller Controller PositionTo change the controller position Foot Platform Depth Adjustment Foot Platform Height AdjustmentFoot Platform Angle Adjustment Batteries and Charging B a T T E R I E S a N D C H a R G I N GCharging the Batteries To charge the batteries using an onboard charger To charge the batteries using an off-board chargerBattery Break-in To break in new batteries for maximum efficiencyFrequently Asked Questions FAQs How can I ensure maximum battery life? Why do my new batteries seem weak?How should I store my power chair and its batteries? What about public transportation?Should your power chair come in contact with water Care and MaintenanceTemperature I . C a R E a N D M a I N T E N a N C EWeekly Checks Daily ChecksTo check the brakes Monthly ChecksCleaning Instructions Disposal of Your Power ChairWheel Replacement StorageQuantum 600 Series DriveWheel Battery ReplacementBattery Installation Corrective Maintenance When to See Your Quantum Rehab Specialist for ServiceTo replace the batteries I I . W a R R a N T Y Warranty Exclusions Reconditioned Units WarrantyService Checks and Warranty Service Exclusions also include components with damage caused bySpecifications P E N D I X I Specification SQuantum 600 Series Dimensions and Ground Clearance T E S Quality Control Quantum 600 Series
Top Page Image Contents