V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away from the armrest, or change the position of the control- ler for either
WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the power base frame.
To extend the controller:
1.Flip up the armrest so it is perpendicular to the floor.
2.Loosen the setscrew on the controller bracket, if equipped. See figure 11.
3.Slide the controller into or out of the armrest to the desired position.
4.Tighten the setscrew to secure the controller.
To change the controller position:
1.Turn off the power to the controller.
2.Unplug the controller harness from the power base.
3.Cut the wire tie(s) that secure the controller harness to the armrest and seat.
4.Flip up the armrest so it is perpendicular to the floor.
5.Loosen the setscrew on the controller bracket.
6.Slide the controller out of the armrest.
7.Loosen the setscrew in the other armrest.
8.Place the controller in the other armrest.
9.Tighten the setscrew to secure the controller.
10.Route the controller harness along the seat frame and secure with wire ties. See figure 7.
11.Plug the controller connector into the power base.
See figure 2.
Foot Platform Position
You can adjust the angle of the foot platform.
To adjust the foot platform angle:
1.Flip up the foot platform and locate the angle adjustment screw. See figure 12.
2.Turn the angle adjustment screw to raise or lower the front of the foot platform.
You may be able to adjust the height and depth of the foot platform. See figure 12.
To adjust the foot platform height:
1.Remove the height adjustment hardware.
2.Move the foot platform to the desired height.
3.Reinstall the height adjustment hardware.
CONTROLLER
BRACKET
SETSCREW
Figure 11. Underside of Armrest
HEIGHT |
|
ADJUSTMENT |
|
HARDWARE |
|
DEPTH | ANGLE |
ADJUSTMENT | ADJUSTMENT |
HARDWARE | SCREW |
Figure 12. Foot Platform Adjustment
16 | www.pridemobility.com | Jazzy Elite Series |