Pride Mobility 1103 Armrest Angle Adjustment, Joystick Extension Adjustment, Joystick Position

IV. COMFORT ADJUSTMENTS

ARMREST ANGLE ADJUSTMENT

You can adjust the armrest angle to fit your specific needs.

To change the armrest angle:

1.Lift the armrest straight up so that it is perpendicular to the floor.

2.Use a 7/16-in. wrench to loosen the locking nut. See figure 6.

3.Use a 5/32-in. hex key to loosen the hex nut. Turn the screw clockwise to raise the front of the armrest and counterclock wise to lower the front of the armrest.

4.Lock the adjusting screw into place by tightening the locking nut.

JOYSTICK EXTENSION ADJUSTMENT

The joystick controller can easily slide out away from the armrest, or in toward the armrest.

To extend the joystick:

1.Use a 3/16-in. hex wrench to loosen the setscrew.

2.Slide the joystick mounting bracket into or out of the armrest to the desired position. See figure 7.

3.Retighten the setscrew by turning it clockwise.

JOYSTICK POSITION

You can position the joystick for either left-hand or right-hand use.

To change the joystick position:

1.Disconnect the controller harness connectors. See figure 3.

2.Cut the wire tie that attaches the controller cable to the arm rest. See figure 8.

3.Use a 3/16-in. hex wrench to loosen the setscrew. See figure 7.

4.Slide the joystick mounting out of the armrest.

5.Loosen the setscrew in the other armrest.

6.Place the joystick bracket in the other armrest.

7.Tighten the setscrew.

8.Connect the controller cable to the armrest with a wire tie. See figure 8.

TURNTHISSCREWTOCHANGE ARMRESTANGLE

LOCKING

NUT

LOCKS

ADJUST-

MENT

SCREW IN

PLACE

FIGURE 6. Armrest

Angle

L O O S E N

THIS

SETSCREW

TO ADJUST

JOYSTICK

FIGURE 7. Joystick

Extension

USE A WIRE TIE

TOSUPPORTTHE

CONTROLLER

CABLE.

FIGURE 8. Wire Tie

Location

Jazzy 1103 19