Installation of the Front Grille

Depending upon the location of the AC outlet, route the AC cord to either the left or right side while installing the front grille.

This figure shows the AC cord routed to the left side.

REMOVAL OF FRONT GRILLE

1Remove the front intake grille.

Pull up the front intake grille about 90° and slide it slightly to the left to unhook the tabs.

Wireless

1 Place the front grille on
the cabinet first.				2 Remove the air filter.
2 Secure the front grille to				2 Remove the air filter.
2 Secure the front grille to
the main chassis using				Tilt up and pull out the air filter
screw provided.				Tilt up and pull out the air filter
screw provided.				by the holder.
				by the holder.
				Air filter
INSERT THE		(OPTIONAL)
Attach the	(part no.		Slot in the	and the
CZ-SF6P)	to the frame.		frame (part no. CZ-SFW6P) to
			the front grille.

The and the frame can be obtained separately from your nearest servicenter.

INSERT THE AIR FILTER

Attach the air filter to the intake grille.

3Remove the front grille.

a Remove the adhesive tape from	b
all sides of the front grille.	b
b At bottom right side of the front	a
grille, press inward on cabinet
near the power cord, and pull
the grille outward to the right
until right tab releases.	c
c At the bottom left side, push	c
inward on cabinet and pull the	d
grille outward to the left to	d
release the left tab. Do not pull
the bottom edge toward you more than 3 inches to prevent the two
top tabs from damage.

dSlide the front grille upwards to free the two top tabs from slots at the top of the cabinet.

HOW TO ATTACH THE DRAIN PAN (OPTIONAL)

Wireless

PLACE FRONT INTAKE GRILLE OVER THE FRONT GRILLE

Slide the front intake grille slightly to the right to reattach the tabs and then push it down to close tight.

Wireless

Lift up about 90°.

Condensed water drainage

This air conditioner employs a “Slinger-Up System” which is designed to splash the condensed water on the condenser coil for maximum cooling efficiency, thus producing a splashing sound.

If the splashing sound annoys you, you can provide an outside drainage by using the following procedure which may, however, cause a small loss of performance.

NOTE

The cabinet should be installed tilted slightly lower to the rear for necessary condensate drainage.

(Max. 13/32”)

Maximum

13/32”

Condensed water