Tools YOU will Need, Power Drive Unit

S e

TOOLS YOU WILL NEED

1. Basic Tool Kit:

To set-up, adjust and maintain your chair you will need the following tools:

•7/16" box and open-end wrench

•1/2" box and open-end wrench

•3/4" box and open-end wrench

•5/32" Allen wrench

•3/16" Allen wrench

•1/8" Allen wrench

•Phillips screwdriver #2

•Custom axle wrench (or a 1/2" open-end wrench)

	I X . S e t - U p , A d j u s t m e n t & U s e	29
	A. POWER DRIVE UNIT
	Wheelchair and Power Drive Attachment	C
	a. Position seat and main frame over power drive unit.	A
	b. Align quick-connect blocks (A) with binding	B
	socket (B) located on power drive unit.	B
	socket (B) located on power drive unit.
	c. Ensure frame is properly located on power drive
	unit and the controller cable is clear.
	d. Press levers (C) down until locked.
	e. Lever force required can be adjusted by adjusting
	screw.

You can obtain a multi-purpose tool kit from Sunrise, or buy the tools you need from a hardware store.

2. Torque Wrench:

If you plan to adjust and maintain this chair yourself, Quickie recommends that you use a torque wrench.

NOTE– The wrench must measure inch-pounds (N.m). You can buy a torque wrench and proper sockets from a hardware store.

CHECK-OUT

Be sure this chair performs to your chosen operational settings. If it does not, turn the chair off immediately and reprogram with the Quickie QTRONIX Programmer. if you do not own a Quickie QTRONIX Programmer have your supplier reprogram your wheel- chair as needed. Or, you can order a Quickie QTRONIX Programmer for your own use from your supplier.

NOTE– Repeat this procedure until the chair performs to your specifications

When properly set-up, this chair will operate smoothly. Check to see that all components work properly. If you detect a problem, be sure to correct it before use.

Always secure levers before operating chair. If the chair fails to operate and the battery charge indicator flashes 9 bars, check both quick-connect levers for securement. Then cycle the on/off switch.

B. BATTERY REMOVAL

To remove the batteries for transporting or servicing:

Remove Batteries

a. Remove seat and main frame from power drive unit using quick-release levers shown above. (C)

b. Remove battery compartment lid by releasing the two (2) quarter turn fasteners (D).

c. Prevent the power drive unit from tipping for- ward by placing a solid object underneath the front of the power drive unit.

d. Lift battery compartment lid (E) off of power drive unit.

e. Disconnect battery leads from power harness. f. Lift rear most battery out using the battery

straps (F).

g. Pull the front battery rearward, disconnect it, and remove it using the battery straps.

Batteries may weigh up to 55 lbs. (25 kg). Care must be taken to avoid injury when lifting.

930466 Rev. A