30 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| X | . |
| S | e t - | U | p |
|
| & |
| A | d | j | u | s t | m | e | n | t | s |
|
I. WHEEL LOCKS
Quickie M6 wheelchairs are shipped with two wheel locks. Wheel locks are installed at the factory unless you have requested otherwise.
Use a torque setting of 100
1.Push-to-Lock Wheel Locks Adjustment (Fig. 13)
a.Using a 3/16" Allen wrench, turn one of the screws in the clamp counterclockwise
b. Repeat the same process with the | Figure 13 |
second of the two screws. |
|
c. Alternately loosen the screws (two turns each) |
|
until both screws are removed. |
|
d. To prevent wheel movement when in the locked |
|
position, slide clamp toward the rear wheel until |
|
the wheel lock is embedded into the tire. |
|
e. Tighten screws. |
|
J. ANTI-TIP TUBES (OPTIONAL)
Sunrise recommends
Use a torque setting of 100
1.Inserting Anti-Tip Tubes Into Receiver (Fig. 14)
a.Press the rear
b.Insert into the
c. Turn the |
|
positioned through the receiver mounting hole. |
|
d. Insert second | Figure 14 |
2.Adjusting Anti-Tip Receiver (Fig. 14)
a.Remove
b.Remove bolts from
c.Reposition bracket to desired height.
d.Reinsert bolts and tighten.
e.Repeat with second
f.Replace
X . S e t - U p & A d j u s t m e n t s | 31 | |
3. Adjusting |
| |
The |
| |
lowered to achieve proper clearance 1 1/2" to 2". |
| |
a. Press the |
| |
release pin is drawn inside. |
| |
b. Raise or lower to one of the three predrilled holes. |
| |
c. Release pin. |
| |
d. Adjust the second |
| |
same way. Both wheels should be at exactly |
| |
the same height. | Figure 15 | |
4. Turning | ||
| ||
Turn |
| |
overcoming obstacles or climbing curbs. |
| |
a. Press the rear |
| |
b. Hold pin in and turn |
| |
c. Release pin. |
| |
d. Repeat with second |
| |
e. Remember to return |
| |
position after completing maneuver. |
| |
| Figure 16 |
930457 Rev. A | 930457 Rev. A |