Sunrise Medical Quickie 2 Lite Plastic Side Guards Optional, Folding and Unfolding, Check-Out

Page 19

P. PLASTIC SIDE GUARDS (OPTIONAL) 31

Installation of side guard hardware.

a.Position outer receiver hardware (A) on frame.

b.On corresponding inside of the frame position inner clamping hardware (B)

c.Insert two bolts with washer and tighten using 3/16 inch hex key

Inserting and Removing of Side Guard

a.Insert Side Guard (D) into Side Guard outer receiver hardware (A)

b.Remove, clutch top of Side Guard and pull upward.

NOTE – After installing receiver hardware and inserting side guard check for interference. Don’t operate the wheelchair that as interference with these other components.

Q. FOLDING AND UNFOLDING

1.Folding Chair

a.Remove quick-release wheels (optional).

Depress quick-release button on the axle.

Remove wheel by sliding out quick-release axle from axle bracket.

Repeat with other wheel.

b.For the Q2 Lite Swing Away model, flip up the footrest to a vertical position before folding the wheelchair.

c.Grasp the seat sling (in the center) and lift sharply until the wheelchair is folded.

2.Unfolding Chair

a.Replace quick-release wheel (optional) by depressing the quick-release button on the axle.

b.Slide it into the axle sleeve until it locks.

c.Repeat with other wheel.

d.Tilt the wheelchair toward you far enough to take the weight off the opposite wheel.

e.Push down on the seat rail (closest to you) until the wheelchair is completely opened.

f.Make sure seat rail tubes are resting in the seat rail saddles.

NOTE– Ensure that footrest is locked prior to use.

R. CHECK-OUT

After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also perform smoothly. If you have any problems, follow these procedures:

1.Review the set-up and check-out sections and operating guide to make sure chair was properly prepared.

2.Review troubleshooting guide.

3.If your problem persists, contact your authorized supplier. If you still have a problem after contacting your authorized supplier, contact Sunrise customer service. See the introduction page for details on how to contact your authorized supplier or Sunrise cus- tomer service.

I X .

31

D

C

B

A

19

108590 Rev. A

 

Image 19
Contents This manual must be given to the rider of this wheelchair Quickie 2 LiteSunrise Listens IntroductionFor Answers to Your Questions II . Table of Contents Backrest Tube Pneumatic Tire Aluminum Handrim III . Your Chair and ITS PartsQuickie 2 LITE- SWING-AWAY Footrest Fixed FrontGeneral Warnings IV. Notice Read Before USEEnvironmental Conditions Changes & AdjustmentsMotor Vehicle Safety When YOU Need HelpVI . Warnings Falls & TIP Overs Curbs & Steps Moving BackwardRAMPS, Slopes & Sidehills TransferVII . Warnings for Safe USE Viii . Warnings Components and Options Push Handles Optional Transit USETransit Option Positioning Belts OptionalUpholstery Fabric Modified Seat SystemsPadded SWING-AWAY Armrests Optional IX . SET- UP, Adjustment & USERear Wheel Axle NUT Adjustment 3 To Mount & Remove Rear Wheels 1Replacing Armrest Fixed Front Footrest Height AdjustmentHeight Adjustment Adjusting Armrest Receiver FitAngle Adjustable Backrest Optional Angle Adjustable FootplatesBackrest Seat Sling Cushion Installation OptionalRear Axles Casters Seat Height AdjustmentAdjusting Caster Angle 23 Wheel LocksInserting Anti-Tip Tubes Into Receiver Adjusting Anti-Tip Tube WheelRe-squaring Your Casters 25 Tip-overFolding and Unfolding Plastic Side Guards OptionalCHECK-OUT Make sure tire pressure is correct and equal in both TroubleshootingXI . Maintenance XII . Sunrise Limited Warranty Page Sunrise Medical Inc