X . S E T U P & A D J U S T M E N T
E. STANDARD & LOW FRONT (HEMI) SEAT HEIGHTS
Note: Adjust seat height for body and mechanical efficiency.
1.Adjustment to 171/2" Seat Height
Rear Wheels:
a.Remove Footrests (p.31) and unfold chair (p.25).
b.While standing behind frame, turn chair face down.
c.Remove right rear axle and lock nut using 5/8" socket wrench and
5/8" box end wrench.
d.Raise wheel to top threaded hole in sideframe, reinsert axle into threaded mounting hole.
e.Tighten axle until there is no vertical play in the wheel using a 5/8" box end wrench.
DO NOT OVER TIGHTEN, DAMAGE TO WHEEL BEARINGS MAY RESULT.
f.Spin wheel to ensure adequate rotation for user function.
g.Install lock nut on threaded axle with a 5/8" socket wrench. Using 5/8" box end wrench to prevent axle from loosening. Torque lock nut to 28 lbs. to 32 lbs.
h.Repeat steps
X . S E T U P & A D J U S T M E N T
Front Casters
a.Turn chair face up.
b.Use 3/16 allen wrench and 1/2 socket wrench to remove two bolts located on right front of caster fork assembly.
c.Lift caster post assembly out of existing position and insert in top mounting hole position.
d.Reattach lock nuts using 3/16 allen wrench and 1/2" socket wrench.
e.Repeat steps
Note: If you plan to use elevating legrests in the 17 1/2" seat height configuration you must lower the elevating legrests. Refer to page 36 for instructions.
28 | 29 |