X . S E T U P & A D J U S T M E N T
3.Footplate Height-Adjustment
a.Use 1/2" box end wrench to loosen nut on clamp located on footrest tube.
b.Adjust footplate to proper position.
c.Tighten nut securely with 1/2" box end wrench.
4.Changing Footrest from Left to Right
a.Remove set screw with #2 phillips screwdriver.
b.Pull footplate off post.
c.Turn 180° and insert footplate back on post. (Be sure that metal strip between footplate and hanger post remains in place. Reinsert if necessary.)
d.Remove carriage bolt and nut from clamp
on footrest tube. (See footplate height adjustment above). Reverse direction of bolt so that nut sits on outside of footrest. Failure to reverse bolt may cause injury to occupant leg and/or ankle.
e.Replace set screw and tighten.
f.See p.33 (Changing Elevating Legrest Direction from Left to Right) for directions if required.
5.Adjusting Position of Release Lever
a.Release Lever has five spring loaded positions.
b.To change position, pull up on lever and turn left or right.
c.Let go of lever and snap into position.
X . S E T U P & A D J U S T M E N T
H. ELEVATING LEGREST (Optional)
1.Installation
a.Follow
(p.
2.Adjustment
a.Lift legrest to chosen position. Legrest will lock in place.
Note: Any weight applied to calfpad and footplate must be relieved before legrest will lower.
b.To lower legrest, press release lever (1) down and lower legrest to chosen position. Legrest will lock in place.
3.Changing Elevating Legrest Direction from Left to Right
a.Remove bolt nut from calf support bracket using 7/16" box end wrench.
b.Turn 180° and place calf support on legrest arm.
c.Reinsert bolt with nut facing outside of chair and secure with 7/16" box end wrench.
d.See page 33, #4 for directions to change footplate from left to right.
continued on page 34
32 | 33 |