Harbor Freight Tools 96514, 96513 operating instructions Maintenance, Wheel Bike Loading

2-WHEEL BIKE LOADING

1.Never attempt to load any dirt bike or other 2-wheel motor bike alone. Always have a qualified adult to assist.

2.Line up the 2-Wheel bike with one of the Tri-Fold Ramp sections.

3.With one person pushing the bike slowly up the Ramp, a helper should be in the bed of the hauling vehicle both to guide and to apply the brake if it is necessary to stop the bike while it is on the ramp. Always have one person with a hand on the bike hand brake for safety.

4.Once the person inside the truck bed has hold of the handle bars, apply the brake and steady the bike while the other person moves behind the bike (but off to one side) and pushes it all the way into the truck bed.

NOTE: While most dirt bikes are light enough to safely load with two people, a third person can make the job easier and safer.

5.Once the bike is safely loaded, secure it with four tie down straps (not included), one on each side of the front, and one on each side at the rear of the bike.

2-WHEEL BIKE UNLOADING

1.Position the Tri-Fold Ramp against the truck tailgate behind the rear tire of the bike and attach the Safety Chain to the truck bed.

2.Remove the tie-down straps (not included). Slowly and carefully while using an assistant, push the bike backwards until the back tire is at the top of the Ramp. With one person on the ground behind but to the side of the Ramp, slowly push the bike onto the ramp. Make sure you always have someone holding the hand brake.

3.Slowly work the bike down the Ramp and onto the ground

Maintenance

1.Clean the ramp after each use. Make sure any dirt, oil, grease, or debris are not on the Ramp.

2.Check the Ramp and Safety Chains and Hooks (1 per Ramp) for cracks, signs of stress, bends, or breakage. Do not use the Ramp if faults are discovered. Take the Ramp to a qualified service technician if repairs are required.

SKU 96513/14 For technical questions, please call 1-800-444-3353. Page 7