Installing the Reclining Back Assembly Figure

NOTE: Only RIGHT side of wheelchair shown for clarity. Left side installs in a similar manner.

DETAIL “B” - REAR VIEW

LEFT OFFSET

WHEEL BRACKET

Longer

Axle Lug

RIGHT OFFSET

WHEEL BRACKET

Longer

Axle

Lug

Countersunk	Hole	U-Bracket
Countersunk	Hole
		U-Bracket
Mounting Hole		Tube
Mounting Hole
		Rear Upright
Right Offset	Clevis	Locknut

Wheel Bracket

Mounting Hole

Hex Screw

OUTSIDE OF

WHEELCHAIR Wheelchair

FRAME Frame

NOTE: Arm socket and mounting bracket not shown for clarity

FIGURE 5 - INSTALLING THE OFFSET WHEEL BRACKETS

INSTALLING THE RECLINING BACK ASSEMBLY (FIGURE 6)

NOTE: This procedure requires two (2) people. One (1) person is needed to support the reclining back assembly during the procedure.

NOTE: Stand behind the wheelchair to determine right and left sides.

NOTE: Ensure the reclining mechanism cables (not shown) are positioned towards the inside of the wheelchair frame.

1.Install the spacer into the pivot bushing at the bottom of the right back cane.

2.Position the pivot bushing with spacer into the right U-bracket .

3.Install a flat head socket screw through the right U-bracket, spacer and pivot bushing.

4.Install a cap nut onto the flat head socket screw. Torque to 120 in./lbs.

5.Align the mounting hole at the bottom of the right reclining back tube with the top clevis on the right offset wheel bracket.

6.Install a hex screw through the top clevis and reclining back tube.

7.Install a cap nut onto the hex screw. Tighten the nut just enough to remove the side play of the reclining back tube with the clevis.

NOTE: DO NOT overtighten the cap nut. Otherwise the reclining back will be difficult to operate. 8. Repeat STEPS 1-7 for the left side of the reclining back assembly.

Tracer® SX5 Recliner Conversion Kit

Part No. 1110194 Rev A