Personal Back Bottom Mounting Hardware
Assembly, Installation and Operating Instructions
Kit No.
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact Carrier/Invacare for fur- ther instruction.
SAFETY SUMMARY
The following recommendations are made for the safe installation of the Personal Back Bottom Mount- ing Hardware:
GENERALWARNINGS
DO NOT install this equipment without first read- ing and understanding this instruction sheet. If you are unable to understand the Warnings, Cautions and Instructions, contact a healthcare profes- sional, dealer or technical personnel if appli- cable before attempting to install this equipment - otherwise, injury or damage may occur.
INSTALLATION WARNINGS
The position of the Personal Back in the different mounting bracket slots is directly related to the chair's stability. When the Personal Back is added to a TILT and/or RECLINING chair, it may cause a decrease in the chair's stability. It may be neces- sary to reposition the FRONT CASTERS, REAR WHEELS, BACK ANGLE,
After ANY adjustments, repair or service and BE- FORE use, make sure that all attaching hardware is tightened securely.
INSTALLATION CAUTION
When using LOCTITE 290, follow the manufac- turers' recommendations.
USERWARNINGS
Skin condition should be checked frequently after the installation of any new seat.
Your therapist and physician should be consulted if you have any questions regarding individual limitations and needs.
Working with your therapist, physician, and rehabilitation technology supplier is the best way to assure that a Personal Back choice matches your individual needs.
As the needs of the individual become more complex, the Personal Back evaluation be- comes more important.
This kit includes the following:
ITEM | COMPONENT | QTY. |
|
|
|
1. | Threaded Latch Pin | 2 |
2. | Nylon Locking Key | 2 |
3. | End Cap for Latch Pin | 2 |
4. | 2 | |
5. | Utility Spring | 2 |
6. | #10 Flat Washer | 2 |
7. | Ziplock Bag * | 1 |
8. | Carton * | 1 |
* NOT SHOWN
INSTALLING HARDWARE (FIGURE 1)
1.Move foam padding on inside of Personal Back shell to access the mounting holes.
2.Insert the Threaded Latch Pin (Item 1) from the back of the Personal Back, threaded end first toward out- side edge of Personal Back. Insert through first hole ONLY.
3.Slide the #10 flat washer (Item 6) onto the threaded end from the inside of the Personal Back.
4.Slide the Utility Spring (Item 5) onto the Latch Pin and slide threads of the Latch Pin through remaining hole.
5.Temporarily screw the Nylon Locking Key (Item 2) onto the Latch Pin to prevent Latch Pin from falling out of the Personal Back. DO NOT USE
LOCTITE YET.
6.Locate the groove on the Latch Pin.
7.Push latch pin fully through Personal Back until retaining groove is visible from inside Personal Back.
8.This requires compressing the spring. Maintain spring in compressed position to access groove.
9.Insert Retaining Ring (Item 4) into groove on Latch Pin.
10.Release Latch Pin. It will be held in place by the Retaining Ring.
1