Invacare Fixed Released Rail/Cane Clamps Sleeve Lock Washer, Fixed Release Clamps For Seat Figure

5.Reinstall the mounting screw, lock washer, and inter- nal mounting screw into the fixed release rail/cane clamp and torque to 75 - inch pounds.

6.Repeat STEPS 1 - 5 for other side.

7.Once fixed release mounting clamps are secured, do one (1) of following:

A.Refer to QUICK RELEASE CLAMPS FOR SEAT in PROCEDURE 2 of this instruction sheet.

B.Refer to USING CLAMPS in this instruction sheet.

Twist Release

MountingClamp

Hooks

Inside of Back Cane

Fixed Release

Clamp

Seat Rail

DETAIL “B”

Sleeve

Lock Washer

4.Install the quick release clamp onto the seat rail so that the fixed portion is flush against and rests on top of the mounting hook and the release portion is between the front riggings and the mounting hook.

5.Reinstall the sleeve, lock washer, and internal mount- ing screw into the quick release clamp and torque to 75 - inch pounds.

6.Repeat STEPS 1- 5 for other side.

7.Once quick release mounting clamps are secured, do one (1) of following:

A.RefertoFIXEDRELEASECLAMPSFORSEATin PROCEDURE 2 of this instruction sheet.

B.RefertoUSING CLAMPS inthisinstruction sheet.

Fixed Release Clamps For Seat (FIGURE 4)

NOTE: Refer to INSTALLATION WARNING in the SAFETY SUMMARY before proceeding.

NOTE: The quick release and fixed release clamps are designed to fit either 1-inch rail tubing or, with insert pro- vided, 7/8-inch rail tubing.

1.	Removethesleeve,lockwasher,and internalthreaded
	mounting screw from the fixed release clamp (DE-
	TAIL “C”) .
2.	Place the fixed release clamp on the seat rail.
3.	If fixed release clamp is not tightly fitted around seat rail

Mounting

Hook

Back Cane

Fixed

Portion

tubing,installinsertprovidedasshowninDETAIL “C” .

4. Install the fixed release clamp onto the back rail so

that the fixed portion is flush against and rests on top of

the mounting hook and is located between the seat rail

Internal Mounting

Screw

FIGURE 3- FIXED RELEASE CLAMPS FOR BACK

Quick Release Clamps For Seat (FIGURE 4)

NOTE: Refer to INSTALLATION WARNING in the SAFETY SUMMARY before proceeding.

NOTE: The quick release and fixed release clamps are designed to fit either 1-inch rail tubing or, with insert pro- vided, 7/8-inch rail tubing.

1.Removethesleeve,lockwasher,andinternalthreaded mounting screw from the quick release clamp (DE- TAIL “C”) .

2.Place the quick release clamp on the seat rail.

3.Ifquickreleaseclampisnottightlyfittedaroundseatrail tubing,installinsertprovidedasshowninDETAIL “C” .

	and the bottom of the mounting hook.
5.	Reinstall the sleeve, lock washer, and internal mount-
	ing screw into the fixed release clamp and torque to
	75- inch pounds.
6.	Repeat STEPS 1-5for other side.
7.	Once fixed release mounting clamps are secured, do
	one (1) of follow ing:
	A. RefertoQUICKRELEASECLAMPSFORSEAT
	in PROCEDURE 2 of this instruction sheet.
	B. Referto USING CLAMPS inthisinstructionsheet.

3