2.Position the backrest into the slot on the seat (FIGURE 3).
3.Push down on the backrest until it sits securely into the seat slot.
4.Check under the seat to ensure the compression tabs on the backrest protrude beyond the seat slot. If they are visible, the backrest is attached properly. If they are not, push the backrest further into the seat slot. Refer to Detail “A” of FIGURE 1.
5.Before using, pull upward on the backrest to ensure the backrest is securely attached and locked into place.
REMOVING
1.Locate the compression tabs underneath the seat.
2.Depress both compression tabs with one hand.
3.Using the other hand, hold the backrest handle and pull up and away from the seat.
4.Release the compression tabs to avoid pinching and continue pulling the backrest up until it is removed from the seat.
Backrest Handle | Backrest |
|
Compression
CompressionTab Tab
Slot in Seat for Backrest
Seat
DETAIL “A” - COMPRESSION TAB
IN LOCKED POSITION
Compression
Tab
Seat
Backrest in
Installed
Position
FIGURE 3 - INSTALLING/REMOVING THE BACKREST
CLEANING
NOTE: Before using any cleaning prodcuts, test an area on the underside of the seat for any discoloration or staining.
1. Use water and a mild soap or non‐abrasive cleanser to clean the shower chair.
IVC™Heavy Duty Shower Chair | 4 | Part No 1122173 |