BOLT-IN-PLACE HEIGHT ADJUSTMENT (FIGURE 1)
NOTE: This procedure applies to the swingaway footrests and swingaway elevating legrest.
1.Remove the swingaway front rigging. Refer to INSTALLING/REMOVING THE FRONT RIGGINGS in the owner’s manual shipped with wheelchair.
NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.
2.Pull the cam lock lever UP to UNLOCKED position.
3.Using a screw driver to hold the riv nut in position, remove the button head screw from the riv nut.
4.Remove the riv nut and button head screw securing the footplate assembly to the front rigging support.
5.Adjust the footplate assembly height by aligning the desired adjustment holes in the upper front rigging support and footplate assembly.
6.From the outside of the swingaway front rigging, insert the riv nut through both the front rigging support and the footplate assembly.
7.From the inside of the swingaway front rigging, insert the button head screw through the appropriate adjustment hole and thread into the riv nut.
8.Using a screwdriver to hold the riv nut in position, securely tighten the button head screw. Torque to 32
9.Rotate cam lock lever DOWN to LOCKED position.
10.Repeat STEPS
11.Reinstall the swingaway front rigging. Refer to INSTALLING/REMOVING THE FRONT RIGGINGS in the owner’s manual shat shipped with wheelchair.
Part No. 1114831 | 3 | |
|
| Front Rigging Kit |