INSTALLING THE SPRING BUTTON FRONT RIGGING KIT (FIGURE 2)
NOTE: This kit allows
1. Remove the front rigging from the wheelchair. Refer to the wheelchair owner’s manual shipped with wheelchair.
\
2.Pull the cam lock lever UP to UNLOCKED position.
3.Using a screw driver to hold the riv nut in position, remove the button head screw from the riv nut as shown in DETAIL “A” of FIGURE 2.
4.Remove the riv nut and button head screw securing the footplate assembly to the front rigging support.
5.Remove the footplate assembly from the upper front rigging support.
6.Perform one of the following as shown in DETAIL “B” OF FIGURE 2:
A.FOOTRESTS:
•With the spring pointing UP, insert the spring button into the footplate tube so that the release buttons FULLY protrude through the top set of mounting holes.
B.ELEVATING LEGRESTS AND FOOTRESTS WITH ADJUSTABLE ANGLE FOOTPLATES:
•With the spring pointing DOWN, insert the bottom spring button into the footplate tube so that the release buttons FULLY protrude through the bottom set of mounting holes.
•With the spring pointing UP, insert the top spring button into the footplate tube so that the release buttons FULLY protrude through the top set of mounting holes.
NOTE: The elevating legrest has two (2) sets of release buttons, one (1) set above the other. Each set will be visible one at a time allowing finer footplate height adjustment.
7.Insert the footplate tube into the front rigging support.
8.Push IN the release buttons and reposition the footplate assembly to the desired height.
9.Ensure that the release buttons fully protrude from holes on both sides of the front rigging support.
10.Rotate cam lock lever DOWN to LOCKED position.
11.Reinstall the swingaway front rigging assembly. Refer to the owner’s manual shipped with wheelchair.
12.Ensure Release buttons are properly seated and FULLY protrude through the adjustment holes before use.
13.Repeat this procedure for the other footplate, if necessary.
4 | Part No. 1114831 | |
Front Rigging Kit |
|
|