INSTALLING THE TELESCOPING TUBE (FIGURE 2)
NOTE: The support bracket must be mounted to the wheelchair BEFORE installing the telescoping tube.
1.Insert the telescoping tube into the support bracket.
2.Rotate the telescoping tube until the mounting holes at the bottom align with the mount- ing holes in the support bracket.
NOTE: The adjustment knob should point towards the outside of the wheelchair.
3.Install the short hex screw and small locknut to secure the telescoping tube to the support bracket. Torque to 120 in/lbs.
4.Adjust I.V. rod to desired height. Refer to ADJUSTING THE I.V. ROD HEIGHT in this instruction sheet.
Telescoping
Tube
Mounting
Hole
Support
Bracket
Short Hex
Screw
Small Locknut 
Adjustment
Knob
Telescoping
Tube
NOTE: Rear wheel not shown for clarity.
FIGURE 2 – INSTALLING THE TELESCOPING TUBE/ADJUSTING THE
I.V. ROD HEIGHT
ADJUSTING THE I.V. ROD HEIGHT (FIGURE 2)
1.Loosen the adjustment knob.
2.Adjust I.V. rod to desired height.
3.Securely tighten adjustment knob.
3