Contracture Footplate Depth Adjustment Figure

Mounting

Screws

CONTRACTURE FOOTPLATE DEPTH ADJUSTMENT (FIGURE 7)

NOTE: Refer to the GENERAL WARNINGS and INSTAL- LATION WARNINGS in the SAFETY SUMMARY of this instruction sheet.

4.Secure the footplate bracket to the contracture sup- port with the mounting screw, two (2) coved washers, washer and locknut. Securely tighten.

5.If necessary repeat STEPS 1-4 on remaining con- tracture footplate.

NOTE: Observe the angle of the contracture footplate for reinstallation.

1.	Remove the two (2) flat screws, washers and lock-
	nuts that secure the contracture footplate to the
	footplate hinge.
2.	Move the contracture footplate to one (1) of four (4)
	mounting hole.

Mounting

Holes

Lock Nut

Contracture Support

Mounting Screws

Coved Washers

3. Reinstall the two (2) flat screws, washers and lock-

nuts that secures the contracture foot plate to the

footplate hinge.

Flat Screws

Washers

Footplate

Bracket

Mounting

Hole

Contracture

Footplate

Washers

Footplate Hinge

Lock Nuts

FIGURE 7 - CONTRACTURE FOOTPLATE DEPTH

ADJUSTMENT

CONTRACTURE FOOTPLATE HEIGHT ADJUSTMENT (FIGURE 8)

NOTE: Refer to the GENERAL WARNINGS and INSTAL- LATION WARNINGS in the SAFETY SUMMARY of this instruction sheet.

1.Remove the mounting screw, two (2) coved washer, washer and locknut that secure the footplate bracket to the contracture support.

2.Move the footplate bracket UP/DOWN to achieve desired height.

3.Align the mounting hole in the footplate bracket with one (1) of seven (7) mounting holes on the contrac- ture support.

FIGURE 8 - CONTRACTURE FOOTPLATE HEIGHT

ADJUSTMENT

REPLACING THE CONTRACTURE FOOTPLATE HEEL LOOP (FIGURE 9)

NOTE:RefertotheGENERALWARNINGSandINSTAL- LATION WARNINGS in the SAFETY SUMMARY of this instruction sheet.

1.Tiltthecontracturefootplateforwardtogainaccesstothe mounting screws that secure the heel loop to the under- side of the contracture foootplate. Refer to angle adjust- ment of the contracture footplate in this instruction sheet.

2.Remove the four (4) mounting screws and washers that secure the EXISTING heel loop to the contrac- ture footplate.

3.Reverse STEPS 1-2 to install the NEW heel loop.

Washers Contracture

Footplate

Washers

Heel Loop

FIGURE 9 - REPLACING THE CONTRACTURE

FOOTPLATE HEEL LOOP

Invacare Corporation	www.invacare.com

USA	Canada
One InvacareWay	5970 ChedworthWay	Invacare and "Yes, you can" are trademarks of Invacare
Elyria, Ohio USA	Mississauga, Ontario	Corporation.
44036-2125	L5R 3T9, Canada	© 2000 Invacare Corporation
800-333-6900	905-890-8838	Form No. 00-97	Part No. 1095349 Rev A (1) 5/00