Harmar Mobility AL003 Hold-Down Arm Installation, With the Tilt and Tote Folded Down Position

Hold-Down Arm Installation

INSTALL

HOLD

DOWN

ARM

ADJUST TO

DESIRED HEIGHT

TIGHTEN

SET

SCREWS

HOLD DOWN ARM HEIGHT CAN

BE ADJUSTED SO THAT WHEELCHAIR's

ARMRESTS CLEAR ARM WHEN LOAD- ING ONTO A TILTED PLATFORM.

HOLD DOWN ARM HEIGHT CAN

WHENBEPLATFORMADJUSTED SO ISTHATTILTEDWHEELCHAIR'sUPRIGHT,

ARMRESTS CLEAR ARM WHEN LOADING

THE ARMRESTSONTO A TILTEDSHOULDPLATFORMBARELY. CON-

TACT WTHENBOTTOMPLA F RM ISOFTILTEDTHEUPARMIGHT,. THE ARMRESTS SHOULD BARELY CONTACT

THE BOTTOM OF THE ARM.

THE REDTHE REDKNOBSTARCANHA DLETHENCAN BETHEN BE TURNED TO CINCH THE WHEELCHAIR

TURNED TO HOLDDOWNTHETIGHTWHEELCHAIR. DOWN TIGHT.

Tilt Away Feature

REMOVE HITCH PIN	ONCE PIN IS REMOVED, THE
WHILE BRACING	TILT AND TOTE CAN BE LOWERED
TILT AND TOTE	JUST BELOW PARALELL WITH THE
UPRIGHT	GROUND BEFORE RESTING ON
	ITS MECHANICAL STOPS.	TO ERECT THE TILT AND TOTE BACK TO
		ITS TRAVEL POSITION,SIMPLY ROTATE
		UPRIGHT, AND REPLACE THE HITCH PIN.

NEVER ATTEMPT TO TRANSPORT

WITH THE TILT AND TOTE IN THE

FOLDED DOWN POSITION.