Taking Weight Measurement only, Troubleshooting

BF-574/576.4.10 02.4.10 4:39 PM ページ 11

TAKING WEIGHT MEASUREMENT ONLY

Select Weight-Only Key

Press the Weight-only key. After 2 or 3 seconds, “0.0” will appear in the display and the unit will beep. When “0.0” appears in the display, step onto the platform. The body weight value will appear. If you remain on the platform, the display will flash for about 30 seconds, and then the power will automatically turn off. If you step off the platform, the weight will continue to show for about 5 seconds, then “0.0” will appear and the unit will shut off automatically.

REPLACING THE BATTERIES

When the batteries run low, the “Lo” message will appear on the display window. When this message appears, be sure to replace the batteries immediately, since weak batteries will affect the accuracy of your measurements. Change all the batteries at the same time with new AA-size batteries.

Note: Your settings will not be erased from the memory when you remove the batteries.

TROUBLESHOOTING

If the following problems occur… then…

A wrong weight reading appears on the display.

Refer to “Switching the Weight Mode” on p.4.

“Lo” appears on the display, or all the data appears and immediately disappears.

Batteries are low. Replace batteries immediately.

The display shows “- - - - -”and goes off when a Personal Key is pressed.

No data (Male/Female, Age, Height, Athlete/Standard Adult) has been stored in the memory for that key. Pre-programme with personal data (p.5).

The display reads “Error” or “- - - - -”appears or the power shuts off while measuring.

Be sure that you have selected the correct user mode (Male/Female, Age, Height, Athlete/Standard Adult). Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides on the measuring platform. Consider whether or not you have selected the correct Personal Key and make sure that you wait for “0.0” to appear before stepping on the platform. Step off and repeat steps on p.6.

“OL” appears while measuring.

Reading cannot be obtained if the weight capacity (23st 8lb/150kg/330lb) is exceeded.

Note: If body fat percentage is more than 75%, readings cannot be obtained from the unit.

The body fat percentage measurement does not appear after the weight is measured.

Vibration will interfere with measurement of the fat percentage. Be sure to stand still on the measuring platform. Do not bend your knees. Be sure that shoes and socks are removed and check foot alignment. Step off and repeat steps on p.6.