Emerson Process Management I-0320 service manual Table of Contents

	TABLE OF CONTENTS
I	INTRODUCTION	4
II	MULTIPORT SPECIFICATIONS	4
IIB	ACTUATOR SPECIFICATIONS:	5
III	MULTIPORT INSTALLATION	6
IIIB	FIELD TECHNICIAN COMMISSIONING ACTIVITIES	6
A.	REINSTALLATION OF THE ACTUATOR ASSEMBLY (also refer to section VII)	6
B.	HOME PORT CALIBRATION (I-0168/RD-00232 Section H)	7
C.	MULTIPORT ELECTRONIC CONTROLLER SET UP	7
IV	MULTIPORT MAINTENANCE	8
V	MULTIPORT ASSEMBLY	8
A.	BODY: (110)	8
B.	PLUG: (130)	8
C.	BONNET: (162)	9
D.	PLUG SEAL ADJUSTMENT (162):	10
VI	MULTIPORT DISASSEMBLY	11
VII	ACTUATOR ASSEMBLY	11
A.	Pedestal, Connector, Speed Reducer, and Motor	11
B.	Local Stepping Command Electrical Conduit, Switchpak Pedestal, and Connector	12
VIII	TROUBLESHOOTING	13
IX	DRAWINGS	14
X	TYPICAL MULTIPORT SEAL COMPONENTS	20
XI	MULTIPORT FLOW SELECTOR NOTES	23
APPENDIX 1: MOTORS		24
A: Baldor Motors		24
B: Elnor Motors		27
C: Pacific Scientific Motors		32
APPENDIX 2: GEAR REDUCERS		36
A: Morse Gearbox		36
B: Boston Gear Gearbox		39
C: Baldor Gearbox		47

Additional manuals:

Multiport Electronic Controller Model MP-08 – Service Manual I-0168 Multiport Electronic Controller Model MP-800 – Service Manual RD-00232

(I-0320--.doc/2)

2