Appliance description
1 Brush head
2 Brush holder
3 Charging station
4 Wall holder
5 Charge indicator
6 Pulse LED (yellow)
7 Soft LED (green)
8 “Clean” LED (orange)
9 On/Off switch
0 Travelling case
Set-up/Wall holder
The charging station 3 may only be operated
In moist rooms, especially in the vicinity of water (bath), the charging station 3 must be firmly fixed to the wall, to protect it from falling into water.
•Pull the wall holder 4 downwards from underneath the charging station 3.
•Using the screw openings of the wall holder 4, mark the spacing for the boreholes on the wall. Check to ensure that there is a mains power socket in close vicinity.
•Before boring the holes, check to ensure that there are no electrical or water conduits behind the markings.
•Affix the wall holder 4 using the plugs and screws.
•When you have attached the wall holder 4, guide the power cable through the right or left recess in the wall holder 4 (see magnification on the
Using the guide rails, slide the charging station 3 onto the wall holder 4.
•Ensure that the power cable is not trapped and that it lies properly in the recesses.
- 4 -