American Standard 2383, 2371 Whirlpool Electrical Installation Instructions, Wire Selection Guide

WHIRLPOOL ELECTRICAL INSTALLATION INSTRUCTIONS

All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other applicable codes.

!WARNING: When using electrical products, basic precautions should always be observed, including the following:

1.DANGER: RISK OF ELECTRIC SHOCK! Connect only to a circuit protected by a ground-fault circuit interrupter.

. Grounding is required. The unit should be installed by a licensed electrician and grounded. . Permit access for servicing motor as noted.

4. All building materials and wiring should be routed away from the pump body and heater (if equipped).

PLEASE SEE THE FOLLOWING TABLE FOR GFCI CIRCUIT REQUIREMENTS:

GFCI CIRCUIT REQUIREMENTS:	FOR MODEL NUMBERS:
The whirlpool should be installed on a 120 vac, 15 amp dedicated	2351
GFCI circuit.
The circuit should be hard-wired from the electrical power supply panel. The	2371
circuit must be a three () wire circuit from the electrical supply panel. A	2383
grounded neutral wire and a third wire, earth ground, are essential.
Optional heater requires a separate 15 amp maximum GFCI circuit.
The whirlpool should be installed on a 120 vac, 20 amp dedicated	2466
GFCI circuit.
The circuit should be hard-wired from the electrical power supply panel. The
circuit must be a three () wire circuit from the electrical supply panel. A
grounded neutral wire and a third wire, earth ground, are essential.
Optional heater requires a separate 15 amp maximum GFCI circuit.

120 VAC

WHITE BLACK

GND.

PUMP/MOTOR

ELECTRICAL DIAGRAM

READ AND FOLLOW ALL INSTRUCTIONS

WIRE SELECTION GUIDE
		Maximum distance from
			fusebox to motor
Motor
	50'		100'	150'	200'
Hi Performance
Rating			115V Power Line
2.1 H.P.,
1.4 H.P.,	12		10	8	8
and 1.25 H.P.

The sizes shown on this

chart are recommendations

for copper conductors only. Always follow local and national electrical codes

754407-100 Rev. B