Kompernass KH 101 Connection to Power Supply, Maintaining the Life of the Rechargeable Battery

Page 7

conduit of the wall bracket. Use only as much cable required to reach the outlet.

CONNECTION TO POWER SUPPLY

Any power point can be used to connect the recharging station – even outlets supplying between 230 and 240 Volt. Place the rechargeable battery component facing you into the recharger. The green charge light flashes as soon as the battery has been placed into the charging station connected to the power supply.

The rechargeable battery may warm up while charging. This does not influence the device’s operation. Overloading the battery is not possible. To maintain its full performance the rechargeable battery should remain in the charging station after every use.

MAINTAINING THE LIFE OF THE RECHARGEABLE BATTERY

To maximise the capacity and the life of the rechargeable batteries charge them for 16 hours before their first use. Then use them until fully empty. Do not leave the charging station constantly connected to the power supply, but connect the plug to the power point for rechar- ging only.

The electric toothbrush is also equipped with an integrated BATTERY PROTECTOR. If the rechargeable batteries are so weak that using them may curtail their service life the indicator signals that recharging should be started. This signal must be observed!

CHARGING SAFEGUARD: After charging commences the indicator flashes for 10 minutes, and while charging changes to constant illumination.

6

Image 7
Contents Page Page Page Operating instructions Safety advice Page Attaching the Wall Bracket What is Plaque ?Your Teeth for Your Entire Life Technical InformationMaintaining the Life of the Rechargeable Battery Connection to Power SupplyPage Pressure Control Cleaning Your Electric ToothbrushReplacing the Brushhead Environment Statement of Conformity