HoMedics SC-630 instruction manual Setting The Zero Point and Balance, Connection Plate

Page 3

SC-630-A.qxd 10/6/06 3:49 PM Page 5

3.Use SCREW DRIVER to hook POTHOOK into the hole of LONG ARM

CONNECTION PLATE

Pothook

Long Arm

Connection

Plate

4.Use ALLEN KEY to remove the pre-set ASSEMBLY SCREW (located on the bottom of the base) to release LONG ARM CONNECTION PLATE into place

Assembly

Screw

5.Use SCREW DRIVER to attach POLE to BASE by inserting and turning the 2 screws tightly

Screws

6. Slide POLE COVER down

5

Setting The Zero Point and Balance

Before using the scale for the first time or when the scale has been moved to another place, you must set the zero point and balance the scale before weighing yourself.

Zero Point

1.With nothing on the PLATFORM, adjust POINTER to ZERO using ADJUSTING KNOB found under DIAL, on the unit’s back side.

Adjusting

Knob

Balance

1.Place the scale on a flat, firm surface

2.Turn 6 LEVELING FEET until the bubble inside LEVEL is directly in the middle of the circle

Level

Locking

Dial

Platform Top

Leveling Feet

Leveling

 

 

 

Foot

6

Page 2 Page 4
Image 3
Page 2 Page 4
Contents IBSC-630A Garantía Limitada DE POR VidaAssembly Instructions Assembly Package ContentsConnection Plate Setting The Zero Point and BalanceZero Point BalanceGeneral Operation Trouble ShootingCare and Maintenance Reaching Target WeightIB-SC630A Limited Lifetime WarrantyBase Vista Frontal Vista Posterior ArmadoContenido del paqueteInstrucciones de armado PiezasAjuste en Cero y Equilibrio Ajuste en ceroEquilibrio Cuidados y Mantenimiento Resolución de problemasEn Caso de Problemas Funcionamiento general
Top Page Image Contents