Press the exhaust valve to remove. the remaining.air from the cuff. 
t When initial pressurization was insufficient, the symbol n I\” wiil appear. Repressurize the cuff to a value 30 to 4OmmHg greater than the previous time.
If an error message is displayed, or you get a reading that you do not believe is accurate, wait 10 minutes before trying again.
Memory Operation ,
1.When a valid measurement is made, the reading data (systolic, diastolic and pulse rate) will be stored in the MEMORY as soon as the unit is turned off.
2.The reading in MEMORY can be viewed at any time (except when another , measurement is in progress) by pressing the MEMORY button. An “M” appears in the lower left corner of the display when you are viewing the data in MEMORY.
3.After another valfdmeasurement is performed, the.results of this current measurement will appear on the display. When the MEMORY button is pressed, the previous reading will appear once on the display (along with the “ M symbol). Then the display will revert to the current reading.
4.When the unit is shut off (either by manually pressing the ON/OFF button or when the
Page 5