NOT DX1700
Before Use
-Please read all of the Instructions for Use and the Important Safety Guards carefully.
-Remove all packaging from the iron.
-Remove the soleplate protector.
- It is normal for a small amount of smoke and a light odor to be produced the first time it is used. This will quickly disappear.
- Particles may emit from iron during first use. They are not harmful and should disappear after the iron has been used.
Helpful Hints
-When ironing, start with fabrics that require a low temperature setting (•) and finish with those which need the highest temperature (•••).
-Mixed fiber fabrics should be ironed on the temperature for the most delicate fabrics. For example a shirt that is
60 % cotton and 40 % polyester should be ironed at the (•) setting for synthetics.
-If spray starch is used, spray it onto the reverse side of the garment. Allow starch to penetrate before ironing by setting garment aside for 30 seconds.
-For best results, use a mesh type ironing board to allow excess steam to escape.
-For delicate fabrics, we recommend carrying out a test on an unobtrusive area of the garment such as an inner seam.
-Adhere to manufacturer recommendations on garment label.
3 Way Auto-Off
- If the iron is not moved while it is plugged in, an internal safety switch will turn it off.
-It will turn off in 8 minutes if left vertically or in 30 seconds if left on its soleplate or tipped
over. A red flashing light indicates that the
- To switch the iron on again, move the iron or gently shake it.
Always unplug iron when it is not use.
Filling with Water
- Ensure the iron is unplugged.
- Slide the variable steam control completely to the left.
- Rest the iron on heel and tilt it forward approximately 1 inch.
- Fill with water (containing no additives) to
the max mark on the water tank. We recommend using a the enclosed filling cup rather than filling under the tap. Iron holds approximately 8.5 oz. of water.
-If you need to add water during ironing, UNPLUG the iron and follow the steps above.
-Ensure iron heats back to temperature afterwards, that means thermostat light will go out.