IMPORTANT SAFETY
INSTRUCTIONS
When using your iron, basic safety precautions should always be followed, including the following:
❑READ ALL INSTRUCTIONS BEFORE USING.
❑Use iron only for its intended use.
❑To protect against a risk of electric shock, do not immerse the iron in water or other liquid.
❑The iron should always be turned ”Off” (refer to “How to Use” section) before plugging or unplugging from outlet. Never yank cord to disconnect from outlet; instead grasp plug and pull to disconnect.
❑Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop cord loosely around the iron when storing.
❑Always disconnect iron from electrical outlet when filling with or emptying of water and when not in use.
❑Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble
the iron, take it to a qualified serviceman for examination and repair. Incorrect reassembly can cause a risk of electric shock when the iron is used.
❑Close supervision is necessary for any appliance being used by or near children. Do not leave iron unattended while connected or on an ironing board.
❑Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam iron upside down or use the surge of steam — there may be hot water in the water tank. Avoid rapid movement of iron to minimize hot water spillage.
SPECIAL INSTRUCTIONS
❑To avoid a circuit overload, do not operate another
❑If an extension cord is absolutely necessary, a cord rated at
SAVE THESE INSTRUCTIONS.
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit into a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.
TAMPER-RESISTANT SCREW
Warning: This appliance is equipped with a
Note: If the power supply cord is damaged, it should be replaced by qualified personnel or in Latin America by an authorized service center.
1 | 2 |