Beko DCU 6130B, DCU 6130W, DCU 6130S manual For the condenser, Place the water tank into its seat

Page 21

A Condensed water is not drinkable!

A Never take out the water tank when the programme is running!

If you forget to drain the water tank, your dryer will stop during the following drying cycles when the water tank is full and the “Water tank” warning light will turn on. If this is the case, press the “Start/Pause/ Cancel” button to resume the drying cycle after draining the water tank.

To drain the water tank:

1. Drain the water as shown on the picturre .

2.If there is lint accumulation in the water tank cover, clean it and press to close.

3. Place the water tank into its seat.

For the condenser

Hot and humid air in the condenser is cooled with the cold air from the room. Thus, the humid air circulating in your dryer is condensed and then pumped into the tank.

CClean the condenser after every 30 drying cycles or once a month.

To clean the condenser:

1.If a drying process has been carried out, open the door of the machine and wait until it cools down.

2.Unlock the 2 condenser locks after opening the kick plate.

3. Pull out the condenser.

21

EN

Image 21
Contents DCU 6130W DCU 6130S DCU 6130B Read this manual prior to initial operation of the product Explanation of symbolsTable of Contents Overview Your DryerTechnical Specifications Important safety instructions General safetyDo not use electrical devices in the product Intended use Children’s safetyClosed Do not allow children sit/climb on or enter in the productInstallation First use Adjusting the feetDisposing of packaging material Transportation of the machineElectrical requirements Electrical ConnectionThis appliance must be earthed Fitting a different plugThings to be done for energy saving Initial preparations for dryingLaundry suitable for drying in the machine Laundry unsuitable for drying in the machineCorrect load capacity Preparing laundry for dryingLoading Drying, they will damage your dryerControl panel Selecting a Programme and OperatingYour MachineProgramme selection Preparing the machineFreshen Up Timer programmesProduct Fiche Programme selection and consumption tableStarting the programme Auxiliary functionProgress of programme Changing the programme after it has startedAdding/removing laundry in standby mode Finishing by cancelling the programmeTo cancel any selected programme Child-proof lockEnd of programme Filter Cartridge / Door Inner Surface Maintenance and cleaningSensor Water tankPlace the water tank into its seat For the condenser22 EN Suggested solutions for problems What is covered? GuaranteeWhat is not covered? Important notesService once the manufacturers guarantee has expired ServiceRepublic of Ireland UK Mainland & Northern IrelandPage