Additional Information, User Maintenance

Additional Information

For dual-voltage dryers (Model HD300): For use in 120V countries, the Dual Voltage Selector should be placed in the 120V position. For use in several countries overseas, you may need to place the volt- age selector in the 230V position. Confirm the voltage available at each overseas location before using the appliance.

For 100-120 Volt Operation - Using a coin or screwdriver, turn the Dual Voltage Selector to the 120V position (A). In this position, the dryer operates in all available heat and speed settings.

For 220-250 Volt

Operation - Use a coin or screwdriver to turn the Dual Voltage Selector to the 230V position. Do not

Aattempt to change to 120V when operating

on 230V. A plug adapter may be neces- sary in certain countries.

User Maintenance

For proper operating performance, the dryer must be kept clean. Blocked or clogged air intake vents will cause the dryer to overheat. If overheating occurs, an automatic safety device will shut the dryer or heat off to prevent damage or personal injury. If the unit or the heat cycles off, unplug the cord and allow the dryer to cool for 10 to 15 minutes before restarting. Be sure air vents are clean.

When cleaning is needed, unplug, and clean dust and lint from air intake open- ings with a small brush. The outer sur- face of the dryer should be wiped clean with a damp cloth only.

For models with a removable filter (HD400) – unscrew cap,

remove the filter, brush lint free.

Replace B filter and

cap. (B)

Caution - NEVER allow the power supply cord to be pulled, twisted, or severely bent. Never wrap the cord tightly around the dryer. Damage will occur at the high flex point of entry into the dryer, causing it to rupture and short. Inspect the cord frequently for damage. Stop use immediately if damage is visible or unit stops or operates intermittently. If the cord or dryer is damaged or does not operate properly, return it to an autho- rized service center for repair. Do not attempted to repair the unit.

Storage - When not in use, your dryer should be disconnected and stored in a safe, dry location, out of reach of chil- dren. Do not wrap line cord around dryer. Allow the cord to hang or lie loose and straight at the point of entry into the dryer. For easy storage, hang the unit from its built-in storage loop.