Operating Your Kambrook Hang-Up Hair Dryer
Hang-Up Hair Dryer
Mounting Instructions
The Kambrook Hang Up Dryer is designed to mount onto the wall using the following procedure:
1.Remove wall bracket from unit.
2.Use the wall bracket as a template to mark position of holes for drilling close to electrical outlet, away from bath or vanity basin.
3.Drill three 4.5mm (3/16") holes and insert the anchor bushings by tapping lightly with a hammer until the shoulder of the bushing rests against the wall.
4.Position wall bracket aligned with the holes then tighten the two bottom screws first, then tighten the top screw.
5.Match the slots on the back of the mounting base with the hooks of the bracket.
6.Press into the hooks and slide down to ensure secure mounting.
7.Plug unit into the nearby electrical
IMPORTANT: Do not install where a person in a bath or shower can reach the unit on the wall or reach the
How To Operate
1.After washing, towel dry hair.
2.Press release buttons to remove dryer.
3.To start the dryer, press the On button on the wall mount unit.
4.Slide the control switch to: LOW position for styling hair MED position for drying hair HIGH for fast drying hair
5.To stop the dryer, just hang it into the mounting base which will automatically switch the unit OFF or push the OFF button.
8
KHH100_IB_A11_FA.indd 8 | 14/09/11 2:32 PM |