6 - PROTECTION OF | GB |
THE ENVIRONMENT |
|
At the end of the life of your product, it should go to a
7 - TROUBLESHOOTING
-Your appliance does not work in the VITAL position: check that the air speed control is not at 0.
-Your hairdryer stops automatically:
check that the rear grille is not blocked with hair; if this is the case, take off the removable rear grille and remove the hair.
WIRING INSTRUCTIONS - FOR U.K. ONLY.SAFETY NOTES - FOR REWIREABLE OR MOULDED PLUG
The mains lead of this appliance may be already fitted with a BS 1363 13 A plug. Should the fuse need to be replaced, a 13 A ASTA approved BS 1362 fuse must be used.
If your socket outlet is not suitable for the plug, then the plug must be removed (cut off if it is a moulded on plug) and an appropriate one fitted. Warning : dispose of a plug that has been cut from the power supply cord, as such a plug is hazardous if inserted in a live 13 A socket outlet elsewhere in the house.
Always replace the fuse cover after fitting a fuse.The plug must NOT be used if the cover is omitted or lost until a replacement is obtained - make certain that only the correct fuse cover is used and fitted.
For plugs with a detachable fuse cover the replacement must be the same as the colour insert in the base of the plug, or as directly by the embossed wording on the base of the plug.
If the detachable fuse cover is lost, a replacement may be purchased from an approved Rowenta Service Centre (see enclosed Service Information leaflet). Information for supply may also be obtained from the plug manufacturer.
U.K ONLY - FITTING A PLUG
Brown or red L
Fit correct
N Blue orfuse black 
Use cable gripper
Important : the wires in this lead are coloured in accordance with the following codes Blue, Neutral, Brown, live. Please read the instructions given below before connecting the cord to a plug. If in doubt, please consult a qualified electrician.
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows :
•the wire which is coloured BLUE must be connected to the terminal which is marked with the letter " N " or coloured BLACK.
•the wire which is coloured BROWN must be connected to the terminal which is marked with the letter " L " or coloured RED.
Neither core is to be connected to the earth terminal of a