American Dryer Hand and Hair Dryer instruction

# erialS # odelM

INSTALLATION INSTRUCTIONS

WARNING: DISCONNECT POWER BEFORE INSTALLING

Note: Automatic dryers DESUNAare not recommendedLA ELECTRICIDADforANTEShair dryingDE HACERuse. REPARACIONES

1. Removal of cover:

A) Remove special allen screw using wrench supplied.

B) To remove cover, place a hand on each side of cover and pull bottom

toward you about 1/4 inch, then push cover up toward top of dryer, releasing cover from mounting plate latch. Lift cover off mounting plate by pulling forward at the bottom and upward at the same time. DO NOT FORCE COVER OFF.

2. REMOVE (2) bolts, washers & nuts from lower mounting holes of automatic dry- ers.

3. Dryers should be placed at least 2 feet (61cm) apart and at least 12” (30cm) from washbasin. Do not install dryer over washbasin. Automatic dryers should be at least 18” (46cm) above any projection which may interfere with the operation of the automatic sensor.

Hold the backplate to the wall at the suggested mounting height. Measure from bottom edge of backplate to the floor (Ref. Dimension “A” Fig. 1)

DR- Hand Dryer		WOMEN	(depends on age)	DISABLED
DR- Hand Dryer	40” (102cm)	38”(97cm)	28-38”(71-97cm)	32”	(81cm)
DR-N Hand Dryer	42” (107cm)	40”(102cm)	30-40” (76-102cm)	34”	(86cm)
DR-NH Hair Dryer	72” (183cm)	68”(173cm)	46-68”(117-173cm)	52”(132cm)

4. Mark the locations of the four mounting holes and the conduit entrance location on the wall. (The conduit entrance is the proper hole diameter for 1/2 inch (13mm) conduit.)

5. Fasten the backplate to the wall where previously marked.

RECOMMENDATION:

Wood wall - No. 16 (M8) wood screws, 2 3/4” (70mm) long Cement or brick - 1/4” (M6) stud expansion bolts, 3” (76mm) long Hollow wall - 1/4” (M6) toggle bolts, length depends on wall thickness

6. Run service wire to the dryer location and connect to the terminal block. IMPORTANT: All units must be supplied with 3 wire service. Use No. 12 wire or larger, as required by local electrical code. The ground wire must be connected to the dryer backplate. Unit must be installed by a qualified licensed electrician.

Connect to a dedicated circuit NOT to exceed 20 amps.

Dryers located in shower rooms or other wet locations should be equipped with ground fault interrupter(s).

7. Carefully replace the cover using tamper-proof bolt supplied. Be careful not to damage circuit board or sensor. Apply a bead of caulk around edge of cover to wall.

AMERICAN DRYER, INC.

12932 FARMINGTON ROAD, LIVONIA, MI 48150, U.S.A.

Telephone (734) 421-2400 • Fax (734) 421-5580

www.americandryer.com • Email: sales@americandryer.com

CHILDRENMEN

______

OWNER’S MANUAL

“DR” HAND and Hair DRYERS

For Installation or Service

Assistance Please Call

(734) 421-2400 or

Email: sales@americandryer.com

Important: Have Model & Serial No. Ready

Rev. September 2006