American Dryer Hand and Hair Dryer owner manual Parts List for DR Models

ALL MODELS	DO NOT MOUNT TOP
	SIDE DOWN
“A”	Figure 1
	FLOOR

THERMOSTAT	TERMINAL BLOCK	BACKPLATE
			SENSOR
			ADJ. POT

Figure 2			MOTOR
	FAN
HEATING ELEMENT		Figure 3

WARNING: DISCONNECT POWER BEFORE SERVICING DESUNA LA ELECTRICIDAD ANTES DE HACER REPARACIONES

-+

PARTS LIST FOR “DR” MODELS				Sensitivity Adjustment
TIMERS ARE FOR PUSH BUTTON MODELS
DR221 TIMER, 115V, 30		SECONDS (DR20)	SP216C	MOTOR, 115V, 60HZ (DR10, DR20)
DR222	TIMER, 115V, 40	SECONDS (DR10)
DR223	TIMER, 115V, 80	SECONDS (DR10NH, DR20NH)	SP217C	MOTOR, 208-240V, 60HZ (DR30)
DR224	TIMER, 230V, 30 SECONDS (DR30, DR50)		SP217C-5	MOTOR, 220-240V 50HZ (DR50)
DR225	Timer, 230V, 80 Seconds (DR30NH, DR50NH)		DR232	SECURITY SCREW & SPECIAL ALLEN WRENCH
DR218	HEATING ELEMENT (DR10)		DR202	COVER, MUST SPECIFY MODEL #, PUSH
DR219	HEATING ELEMENT (DR20)			BUTTON OR AUTOMATIC, AND COLOR.
DR220 HEATING ELEMENT (DR30, DR50)			DR239-P	COMPLETE WITH ACCESSORIES.
DR227	THERMOSTAT (CIRCUIT BREAKER)			SENSOR COMPLETE, 110-240 VOLT (AUTOMATIC MODELS)

SERVICE AND MAINTENANCE OF YOUR DRYER

Each component used in your dryer has been designed to provide years of trouble free service. However, if trouble should develop, it can nor- mally be located by visual examination. Removal or replacement of most parts is simple and can be done without special tools.

IF COLD AIR IS COMING FROM THE NOZZLE:

Remove the cover and check the heating element. If the element is broken or burned out, replace it.

IF NO AIR IS COMING FROM THE NOZZLE AND HEATING ELEMENT GLOWS:

Remove the cover and check to see that the fan revolves freely. Check and replace motor, if required.

IF NO AIR IS COMING FROM THE NOZZLE AND HEATING ELEMENT IS NOT IN OPERATION:

Check the thermostat. Assuming the thermostat is okay the timer or sen- sor should be replaced.

IF DRYER WILL NOT SHUT OFF:

Make certain the push button returns out fully after being pushed in and released. If button moves freely, replace the timer.

AUTOMATIC DRYERS:

Check that circuit board and sensor are clean from dust and lint (care- fully dust off). Make sure plastic window is clean on both sides. Foam piece on window must remain intact. When replacing dryer cover, be careful not to damage circuit board or sensor.

This dryer is activated by an infrared sensor. The dryer operates as long as hands are below nozzle. There is a maximum 80 second run- ning time with a safety over-ride feature, if hands are not removed. Sensitivity is adjustable (Figure 3) by CAREFULLY turning the adjust- ment pot located on the sensor. Use a small flat blade screw driver. 1/3 Turn MAX. Turn CLOCKWISE to INCREASE sensitivity, COUNTER- CLOCKWISE to DECREASE sensitivity.

FOR ANY OTHER PROBLEM, CONTACT FACTORY FOR ASSISTANCE.

CLEANING - DO NOT spray cleaning solvents thru dryer vents. DO NOT use abrasive, chlorinated, or highly alkaline cleaners. DO NOT use oil based cleaners.

SEMI-ANNUALLY remove the cover and clean all lint and dust from the mechanism, inside of cover, and plastic window.

Clean cover with a mild soap or detergent and warm water, using a soft cloth or sponge.