Reassembling the Mow-Ball™ Support Assembly
WARNING! Before performing any maintenance procedure, stop the engine and disconnect the spark plug wire.
Important: Improper installation can cause damage to your machine’s bearings. Following these directions carefully will protect your machine from damage.
Reassemble the components in the order shown in Figure
21
1.Position the backup plate with the curve facing up. (Figure 21)
2.Stack the line plates on top of one another with the bumps on the bottom locking into the grooves on top of each plate.
3.Place the head of the Mow- Ball™ bolt so it is sitting in the groove at the bottom of the
4.Hold the bolt head in place with your finger and turn the
Figure 21
DR® TRIMMER/MOWER™ Safety & Operating Instructions | 27 |