Before use, Parts identification, Charging

Before use

This Wet/Dry shaver can be used for wet shaving with shaving lather or for dry shaving. You can use this water- tight shaver in the shower and clean it in water. The following is the sym- bol of Wet shaver.The symbol means that hand-held part may be used in a bath or shower.

Treat yourself to wet lather shaves for at least three weeks and notice the difference. Your Panasonic Wet/ Dry shaver requires a little time to get used to because your skin and beard need about a month to adjust to any new shaving method.

Parts identification

(see fig. 1)

AProtective cap

BSystem outer foil

CInner blades

DSystem outer foil release buttons

EBattery capacity monitor

FCharge status lamp

GOn/Off switch

HTrimmer

ITrimmer handle

JAdaptor

KPower cord

READ ALL INSTRUCTIONS BE- FORE USE.

Charging

Connect the power cord to the shaver, and plug the adaptor into an AC outlet. (see fig. 3)

The shaver will be adjusted automati- cally to voltages between 100-240V AC.

In some areas, a special plug adap- tor may be required.

•When charging the shaver for the first time or when it has not been in use for more than 6 months, the charge status lamp may not illumi- nate for a few minutes after opera- tion. It will eventually illuminate if kept connected.

Adequate ambient temperature for charging is between 15 to 35 °C.

•If it is far below or over the appropriate temperature, the charging time may be extended, or the adaptor may not function.

•In particular, low temperature may shorten the life span of the rechargeable battery. In this case, the charge status lamp blinks twice in 1 second.

The charge status lamp will glow when the shaver is being charged. The battery capacity monitor will fully illuminate and the charge status lamp will blink after charging is completed (see fig. 2).

10 minutes after charging is com- pleted, the battery capacity monitor will extinguish and the charge status lamp will continue to blink (see fig. 2).