Maintenance
Disposal
Replacing Cutters and
Screens
To prevent inadvertent damage to the cut- ters and screens,do not attempt to remove them from the head assembly unless you are replacing them.Removal instructions are included with the cutter and screen replacement packages.
To replace a cutter assembly that is removed unintentionally:
1.Hold the cutter in the middle.The blades will not cut your fingers,so no special handling techniques are
necessary.
2.Align the cutter so the little bar on the bottom meets the opening in the clip.
3.Press down on the center of the cutter until it snaps into place. Do not push down on the ends of the cutter, as you may bend the cutter, reducing its ability to cut cleanly.
4.Do not separate the cutter’s blades from the plastic pieces they are attached to, as this may damage the assembly.
When is it time to replace your screens
and cutters?
Because they are subject to daily use,the cutters and screens of your shaver will wear and eventually require replacement to maintain a close,comfortable shave. It is very important to replace your screens and cutters when necessary to ensure a close, comfortable shave without irritation.
Depending on your shaving technique and habits,the screens will usually last 6 months; the cutters,12 months.If you are replacing the cutters,it’s a good idea to replace the screens at the same time.
Here are some signs that your screens and cutters need replacing:
Irritation: As screens get worn,you may notice that your skin feels more sensitive after a shave,particularly when you apply aftershave.
Pulling: As cutters wear, your shave may not feel as close and you may feel your shaver is pulling at your whiskers.
The replacement part for this shaver is model
U.S.residents:
To order shaver accessories call
Canadian residents:
To order shaver accessories,please call
Battery Removal
When your rechargeable shaver reaches the end of its useful life,the batteries must be removed from the shaver and be recycled or disposed of properly in accordance with your state and local requirements.If this is not required by law, you may elect to dispose of the shaver without removing the batteries.
CAUTION:DO NOT PUT IN FIRE OR MUTI- LATE YOUR BATTERIES WHEN DISPOSING AS THEY MAY BURST OR RELEASE TOXIC MATERIALS.DO NOT SHORT CIRCUIT AS IT MAY CAUSE BURNS.DISPOSE PROPERLY IN ACCORDANCE WITH YOUR LOCAL AND STATE REQUIREMENTS.
!Make sure shaver is unplugged before you begin,to avoid a possible electric shock hazard.
1.Press the two side buttons and pull off the shaver head
1
assembly.
2.Remove the 4 outer
2
screws from inside the shaver head.Loosen the top assembly from the body.
3.Remove the screw from the back of the shaver near the power port.
3
4.Remove the two side panels to allow removal of 2 more screws.
4
5.Pry off the back cover of the shaver, starting at the gap below the shaver socket.
5
6.Cut or break the wires attached to the battery on the right.
7.Pry both of the batteries loose from the foam adhesive tape on the PCB.
8.Cut or break the wires connecting the batteries to the PC board.
12 | 13 | ||
|
|
|
|
|
|
|
|
|
|
|
|