How to Use
Charging
Before using your shaver for the first time, put
it on charge for 24 hours.
Preparing the System
Cleaning solution:
1.Press the latch but - tons on the sides of
1
the cleaning base and lift the upper portion off the unit. You will need to keep the buttons pressed in as you
move the upper
2
portion away from the base.The clean- ing solution tank is in the unit’s bottom portion.
5.Replace the top portion of the cleaning base by lining up the three tall posts with the three holes in the tank.Push the top portion down until the two latches click into place.
6.You can dispose of the bottle and cap with your normal trash,or recycle where local ordinances apply.
Operating the
Charging/Cleaning System
Plug the power cord into the cleaning base and then into an electrical outlet.
Place the shaver into the unit,head side down,and slide its “tail”toward the “neck”of the base until it clicks into place.
Charging
Your shaver automatically begins to recharge as soon as it clicks into place in
the cleaning base.While it is charging,the
Solution levels
The cleaning solution will slowly evaporate with use. When the solution levels get lo w, the red replacement indicator light will begin to flash. This means you have enough cleaning solution left for approxi - mately 5 more cleanings.If the red light stops blinking and glows steadily, the unit will not operate until the solution and filter have been replaced.
Replacing the Filter and Solution
®
Only the Remington special cleaning solution and filter can be used with the Smart System.The cleaning solution contains a high percentage of alcohol and a special oil that lubricates your shaver each time it is cleaned.The filter is specially designed to collect hair debris yet allow for the system to clean your shaver.
To refill the cleaning solution and replace
To Charge Your Shaver
The
■ Use only the charging adapter supplied |
with the shaver. |
■ Make sure your shaver is turned off. |
■ Connect the cord to the shaver, then |
plug the charging adapter into the elec- |
trical outlet.A charging indicator light |
will come on. |
■ Your shaver cannot be overcharged,so |
you can leave it plugged in and charg - |
ing between shaves. |
■ To preserve the life of the batteries,let |
them fully run out every six months, |
then recharge them for a full 24 hours. |
■ Cord/cordless rechargeable shavers |
can run directly off the cord if neces- |
sary. They will not recharge while you |
2. Remove the filter
from the tank and
set aside.
3
green indicator light will flash; when it is fully charged the green light will stop blinking and glow steadily.
the filter, follow the steps for "Preparing the System" above.But before replacing the upper portion of the unit,rinse out the tank with fresh water and allow it to air dry to
are shaving,so after shaving with the |
cord,turn the unit off and set it aside to |
charge.Cord/cordless shavers should |
not be used strictly as |
3.Pour the bottle of cleaning solution into the base of the unit through the
opening where the filter was removed. Fill tank to the bottom of the fill tab.
4.Place the filter back into its original position.
NOTE: It is important to make sure the filter is in place.The filter collects hair clippings and debris,and should be replaced along with the solution. Failure to do so will permanently clog the system rendering it inoperable.
Cleaning
To activate cleaning mode,simply press the CLEAN button on the cleaning base.The yellow indicator light flashes through the entire cleaning cycle,which lasts approxi- mately 25 minutes.When the cleaning cycle has been completed,the yellow light will stop blinking and glow steadily. The unit then returns to charging mode.
!Wait until the cleaning cycle has finished before removing the shaver from the base. If the shaver is removed during the clean - ing cycle it will be covered with cleaning solution and be unuseable.
remove any sediment.
Wipe off the unit periodically with a damp cloth and remove any hair debris that has collected where the shaver sits.
!To avoid damage to the cleaning system, use only Remington special cleaning solution.
®
The Remington replacement solution and filter is model
Canadian residents: For shaver accessories, please call
shavers,as continued |
will result in reduction of battery life. |
■ Quick Charge provides up to three |
weeks of shaving after a |
charge,or a single shave after a |
|
■ If your shaver’s charge runs out in the |
middle of a shave,you can push the |
power reserve button to get an extra 5 |
minutes of power. |
NOTE: If your shaver battery is completely discharged or the shaver has not been used for a long time,the shaver may not start when operated using the cord.If this happens,charge the shaver for approxi- mately five minutes before shaving.
8 |
|
|
| 9 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|