Cleaning your shaver:
TO ASSURE OPTIMAL PERFORMANCE,WE RECOMMEND THAT YOU CLEAN YOUR SHAVER AFTER EACH USE.The cutting system of this shaver was designed to be cleaned by rinsing under warm running water or by brushing.(Water temperature should be between 40°C/104°F and 70°C/158°F.)
Cleaning your shaver is easy. (NOTE:With MS3-4700 model,
the brush icon will blink to remind you to clean your shaver.)
■Remove the shaver head by squeezing on both side buttons and pulling away from the body of the shaver. You may blow out the stub- ble thoroughly, or rinse the shaver head in water.
Important: Never clean the screen with the enclosed brush as damage may occur to the holes in the screen.
■At least once a week,the cutters and the trimmer should be cleaned with the cleaning brush. You can also rinse the cutter under running water, like the screen.
Caution: Never put the shaver completely under water. Do not use an y aggressive cleansing agent as this may destroy the shaver coatings.
■To clean and lubricate your shaver’s cutters and head assembly, apply Remington® Shaver Saver®
Caution: Do not remove or replace the head assembly while shaver is running as it may cause damage to the unit’s screens or cutters.
■Worn or damaged parts should be replaced with Remington® replacement parts only.
Replacing Screens and Cutters
Because they are subject to daily use,the cutters and screens of
®
your Remington shaver will wear and eventually require replace- ment to maintain a close,comfortable shave. Depending on your shaving technique and habits, the screens will usually last six months; the cutters,one year.
When is it time to replace your screens and cutters?
It is very important to replace your screens and cutters when nec- essary to insure a close,comfortable shave without irritation. We recommend they be replaced every 12 months.
Irritation: As foils get worn,you may notice that your skin feels more sensitive after a shave,particularly when you apply after shave.
Pulling: As cutters wear, your shave may not feel as close and you may feel your shaver is pulling at your whiskers.
The replacement for this shaver is model
To prevent inadvertent damage to the screen and cutter assembly, do not attempt to remove them unless you are replacing them. To remove the old screens and cutters follow the instructions that come with the screen and cutter, replacement pack- age.It’s always a good idea to replace the screens when you replace the cutters.
To Replace a Cutter Assembly That is Removed
Unintentionally:
■Hold the assembly in the middle of the "T".
■Gently slide the plastic portion of the cutter assembly over the top of the oscillator tip.
■Do not push downward on the ends of the cutters,as you may bend the cutter, reducing its ability to operate smoothly.
■Do not remove cutters from the plastic pieces to which they are attached,as you may damage the assembly.