Charging, Troubleshooting, Battery Removal

Charging

Prior to using your shaver for the first time, put it on charge for 24 hours.

To charge your shaver:

■Make sure your shaver is turned off.

■Connect the cord to the shaver and then the charging adapter to the electric outlet. A charging indicator light will come on.

■Your shaver cannot be overcharged, so you can leave it plugged in and charging between shaves.

■Use only the charging adapter supplied with the shaver.

■The R-9100/-9200/-9300/-9250/-9350/R-TCT come with a special feature that allows you to run the shaver directly off the cord. Your shaver will not recharge while you are shaving, so after shaving directly from the cord, turn the unit off and set aside to charge.

■The R-9100/-9200/-9300/-9250/-9350/R-TCT will provide up to two weeks worth of shaving after a one hour charge or a single shave after five

minutes of charging.

Model R-9100

has a green indicator light to show whether the shaver is either fully charged or charging. A red low-battery indicator illuminates to show when the shaver needs recharging. This also indicates approximately 5 minutes of shaving time left when indicator first comes on. Model R-9200/-9250

features a green lighted fuel gauge that displays the amount of charge remaining in 20% increments. When only 20% of the charge remains,the recharge red warning light illuminates.

Model R-9300/-9350/R-TCT

has an LCD display numeric indicator to show shaver charge status in minutes remaining. When the Plug icon comes on,it indicates approximately 5 to 6 min- utes of shaving time left.

Troubleshooting:

■If your R-9100/-9200/-9300/-9250/-9350/R-TCT shaver bat- tery is completely discharged or the shaver has not been used for an extended period of time, the shaver may not start when operat- ed using the cord. If this condition occurs, charge the shaver for approximately five minutes before shaving.

■Your R-9100/-9200/-9300/-9250/-9350/R-TCT cord/cordless shaver should not be used strictly as a cord-operated shaver, as continued cord only use will result in reduction of battery life.

■In order to preserve the life of the batteries, they should be fully discharged every six months and then fully charged for 24 hours.

World Wide Voltage (all MicroFlex ® TCT™ models)

You can take your shaver with you when you travel to just about

®	™
anywhere in the world. Your MicroFlex TCT	shaver features

worldwide automatic dual voltage conversion providing AC current between 100-240 volts AC, 50-60 Hz. Just plug it in to the local outlet (you may need an adapter plug) and use as usual.

Your shaver will convert automatically to the local current requirements.

Battery Removal:

When your rechargeable shaver reaches the end of its useful life, the batteries must be removed from the shaver and be recycled or disposed of properly in accordance with your state and local requirements.

THE FOLLOWING PROCEDURE SHOULD BE FOLLOWED

FOR BATTERY REMOVAL:

■To avoid a possible electric shock hazard,unplug cord from elec- tric outlet and shaver.

■Open the head assembly by pressing the

head release buttons and lifting the head assembly. Pull the entire head assembly off of the shaver assembly.

■Push the trimmer button up to open the trimmer.

■Remove the trimmer assembly by squeezing the sides as shown in the picture.

■Using a small Phillips head screwdriver, remove the 3 screws from the back of the shaver.

■Pull or gently pry the shaver halves apart, exposing the battery.

■Pry the lower battery clip off.

■Lift or pry the batteries out of the shaver.

■Cut the wires on both ends of each battery and remove them from the shaver.

CAUTION:DO NOT PUT IN FIRE OR MUTILATE

YOUR BATTERIES WHEN DISPOSING AS THEY MAY

BURST OR RELEASE TOXIC MATERIALS. DO NOT SHORT CIRCUIT AS IT MAY CAUSE BURNS. DISPOSE PROPERLY

IN ACCORDANCE WITH YOUR LOCAL AND STATE REQUIREMENTS.

The EPA certified RBRC® Battery Recycling Seal on the nickel- cadmium (Ni-Cd) battery indicates Remington Products Company, L.L.C.is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC® program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which

may be illegal in your area. Please call 1-800-8-BATTERY™for information on Ni-Cd battery recycling and disposal bans/restriction in your area. Remington Products Company, L.L.C.’s involvement in this program is part of our commitment to preserving our environment and conserving our natural resources.