Cleaning your shaver:
TO ASSURE OPTIMAL PERFORMANCE, IT IS RECOM- MENDED THAT YOU CLEAN YOUR SHAVER AFTER EACH USE. The cutting system of this shaver was designed to be cleaned by rinsing under warm running water or by brushing.
■To clean and lubricate your shaver’s cutters and head assembly, apply Remington® Shaver Saver®
When is it time to replace our heads
and cutters?
It is very important to replace your heads and cutters when necessary to insure a close, comfortable shave without irritation. We recommend they be replaced
Cleaning your Remington® MicroFlex®TCT™ Shaver is easy. (NOTE: With the
icon will blink to remind you to clean your shaver.)
■Open the hairpocket by squeezing on both buttons and rotating awa y from the body of the shaver. You may blow out the stubble thoroughly, or rinse the shaver head in water. Rinse both sides of the head assembl y.
■At Least Once a Week:
For more complete cleaning, remove the cutter retainer assembly from the hairpocket by turning the center knob approximately 1/4 turn counter clock-
wise. Hold cutter retainer assembly as shown, and remove head by turning approximately 1/8 turn in the direction shown. Brush clean both the head and the cutter. Reassemble head to cutter retainer assembly by aligning and turn -
ing head 1/8 turn in the opposite direction. Repeat this process for each of the 3 heads. Clean each head and cutter set one at a time to prevent mixing cutter compo- nents.(These should be kept as sets). After cleaning, place cutter retainer assembly in the hairpocket, and secure by turning center knob
approximately 1/4 turn clockwise.
Caution: Never put the shaver |
| Hairpocket |
completely under water. |
| Head |
| ||
Do not use any aggressive |
| Cutter |
cleansing agent as this may |
|
|
destroy the shaver coatings. |
|
|
Caution: Do not remove or replace the head assembly while shaver is running or plugged into an electrical outlet as it may cause damage to the unit’s cutters.
■Worn or damaged parts should be replaced with Remington®
replacement parts only.
every 12 months. Here are some signs of head and cutter wear, indicating that replacement is needed.
Irritation:
As the heads get excessively worn there may be some skin irritation. This would be especially noticed when applying After Shave lotion.
When the cutters wear you may feel a sense of “pulling”and a loss of closeness when you shave. This is an indication that it is time to replace your heads and cutters.