How To Use
Cleaning & Maintenance (without using base)
NOTE: To avoid damage to the cleaning system, use only Remington’s special cleaning solution.
Remington’s replacement solution and filter is model
Canadian residents: For shaver accessories, call (800)
Model R-1000
A blue lighted fuel gauge displays the amount of charge remaining in 20% increments. When only 20% of the charge remains, the recharge red warning light illuminates.
Troubleshooting:
■If your
■Your cord/cordless shaver should not be used strictly as a cord- operated shaver, as continued cord only use will result in reduction of battery life.
■In order to preserve the life of the batteries, they should be fully discharged every six months and then fully charged for 24 hours.
Cleaning your shaver
TO ASSURE OPTIMAL PERFORMANCE, IT IS RECOMMENDED THAT YOU CLEAN YOUR SHAVER AFTER EACH USE.
Before cleaning, detach the handheld unit from the power supply cord before cleaning. The cutting system of this shaver was designed to be cleaned by rinsing under warm running water or by brushing.
Cleaning your Remington® branded shaver is easy.
■Open the hair pocket by pressing the release button and rotating away from the body of the shaver. You may blow
out the stubble thoroughly, or rinse the shaver head in water. Rinse both sides of the head assembly.
■At Least Once a Week:
For more complete cleaning, remove the cutter retainer assembly from the hair pocket by turning the center knob approximately 1/4 turn counter clockwise. Hold cutter retainer assembly
as shown, and remove head by
turning approxi- mately 1/8 turn in the direction shown. Brush clean both the
head and the cutter.
Reassemble head
to cutter retainer assembly by align- ing and turning
head 1/8 turn in the opposite direction.
Repeat this process
for each of the 3 heads. Clean each head and cutter set one at a time to
prevent mixing cutter
components. (These should be kept as sets). After cleaning, place cutter retainer assembly in the hair pocket, and secure by turning center knob approximately 1/4 turn clockwise.
Caution: Never put the shaver completely under water. Do not use any aggressive cleansing agent as this may destroy the shaver coatings.
■To clean and lubricate your shaver’s cutters and head assembly, apply Remington® Shaver Saver®
Caution: Do not remove or replace the head assembly while shaver is running or plugged into an electrical outlet as it may cause damage to the unit’s cutters. The shaver shall not be used until it has dried.
■Worn or damaged parts should be replaced with Remington® branded replacement parts only.
10
11