Install M Series Arm

1.The Slide has (2) ¼-20 x ¾” SHSS set screws that, when tightened, secure the Arm at the desired location within the Channel.

2.While supporting the bottom of the Arm with one hand, guide the Slide (at the rear of the arm) into the top of the Channel.

3.Once the Arm is at the desired height, tighten both set screws using the supplied 1/8” (3 mm) hex key.

Slide Pick & Go Base into Mounting Plate

1)Align the mounting adapter located at the bottom of the Pick & Go base with the edge of Mounting Plate. Slide the Pick & Go base into the plate until it stops at the Spring Plunger (located below the Mounting Plate).

Pull the Spring Plunger and continue to slide the base until the mounting adapter engages the Spring Plunger. Tighten the (4) nylon thumb screws on the back of the Mounting Plate.

Install 4” Cato Channel on Right Side

As described on Page 1 of this document.

Install Power Supply Mounting Adapter to Siemens Power Supply Mount (Siemens P/N: 4720129)

1) Install according to the instructions included with the adapter.

Slide Power Supply Mount into Channel & Insert Power Supply

1) Align the Slide of the mount with edge of the Channel insert into channel.

DU-DR-0016-SC9000 Rev A 6/4/02 GCX Corp. Page 2 of 4